The Baja Designs S2 Sport Flush Mount Work/Scene pair (SKU 547808) puts two compact LED pods with clear lenses into a single reverse-kit package. Each pod pairs LEDs with a powder-coated cast aluminum housing and a hardcoated polycarbonate lens, and the manufacturer lists built-in overvoltage protection. Buying the pair with its harness avoids sourcing a separate harness and bezel hardware for a cheaper single pod, and the flush-mount bezel gives a cleaner profile than surface brackets on a bumper, tailgate, or rack.
The kit is listed as universal, so the real fitment question is the mounting surface. Owners on user forums have flush-mounted the S2 in a Gen 2 Ford Raptor bumper, where the flat area is tight, and one reported that a small gap closed once the bolts were snugged. Other owners cut into factory bumper reinforcement and used stainless nutserts, while some preferred clamp-on brackets to avoid cutting at all. Searching for "S2 Sport work scene backup light," "flush mount LED pod bumper install," or "aux switch LED pod relay wiring" will surface the most owner-tested setups.
Yes. The product is sold as a reverse kit with a harness, and the manufacturer has stated that its reverse kits include what is needed to install and wire the lights into a bumper.
The manufacturer has said there is no quick cover-change solution for the flush mount bezel, so plan on the clear Work/Scene lens unless you are prepared to remove the light.
The manufacturer lists the kit as universal, so confirm the mounting surface yourself. Owners on user forums report that a Gen 2 Raptor bumper has limited flat surface, but a flush fit is achievable with careful measurement.
This is a moderate-difficulty install that is manageable for a careful DIYer with basic tools. Owners on user forums recommend making a paper template, marking the hole locations with a level, and measuring twice before cutting, since the metal in some bumpers is thin. Tools that owners mention include a rotary cutting tool, calipers, and a level, plus 8-32 nutserts if the bumper material cannot hold bolts directly. Route the harness through a separate pass-through hole, and run the lights through a relay and switch. Owners report the pair draws about 1.7 A, so size your fuse and relay to that load. Baja Designs also notes that the flush bezel requires a precise hole, so confirm the diameter with the manufacturer's template before cutting.
