The Baja Designs S1 Spot (part 380001) is a 2.1-inch cube auxiliary light built around a single LED and a reflector tuned for a narrow, long-throw beam. The S1 utilizes a highly specialized reflector and LED combination to outshine the competition. Its hard-anodized, powder-coated cast aluminum housing and billet aluminum bezel are rated IP69K and IK10, so it is built for rock strikes, mud, and pressure washing. Compared with a stock halogen or a generic cube, the value is in sealing and serviceability: the uService technology lets you replace a damaged lens or fine-tune the beam pattern without buying a new light.
Owners on user forums say the S1 is super bright for such a small package, and one owner used a pair to supplement a factory high-beam. The Spot pattern is a narrow, far-reaching beam meant for distance down a trail or road, and the manufacturer positions it to pair with wide or combo lights rather than replace them. Because the light fits a 2.1-inch envelope, it suits tight spaces like bumper pockets, A-pillars, and motorcycle or UTV mounts where a full-size bar will not fit. Search terms this light matches include S1 spot LED pod 380001, 2.1 inch cube LED off-road light, IP69K spot pod, and universal auxiliary driving light with bracket.
The manufacturer states the S1 line uses replaceable lenses and optics, so a damaged lens can be swapped and the beam pattern can be changed without replacing the whole light.
Yes. The manufacturer's installation sheet for the S1 family states that Baja Designs lights must have circuit protection, either a fuse or a circuit breaker, in the power line.
The S1 is a bracket-mounted, wire-in light, so it is a moderate DIY job that mostly comes down to finding a solid mounting point and running clean power. The manufacturer's general S1 mounting sheet describes attaching the bracket to the light with a 1/4-20 bolt and 5mm hardware, and tightening the lower bracket until the light is secure. Route the power leads away from moving parts and heat sources, and include a fuse or breaker close to the battery as the manufacturer requires. Owners on user forums note that a higher mount gives better reach, and that a DIY bracket made from aluminum stock works well if you do not want to use the included hardware.
