The Baja Designs 453001 is a 30-inch straight OnX6+ LED light bar with a spot pattern and clear lens, sold under the OnX6 series name. Its 18 LEDs sit in an aircraft-grade aluminum housing with a black, mil-spec hard anodized finish. The bar uses the brand's High Speed Spot reflector, the same design its Team Enlightened racers use, which the manufacturer says is meant to project light farther down the trail or road than a standard spot. Buyers replacing a stock bumper or budget bar get a bar with a true high/low function, a clear and replaceable lens, and a long warranty. Its IP69K rating, MIL-STD-810G testing, and IK10 impact rating address the stone strikes, washdowns, and vibration that cheaper bars often fail under. Search terms this bar matches include 30 inch spot LED light bar, OnX6+ high/low, and IP69K off-road light bar.
This is a universal-fit bar, so the mounting method and harness determine how it installs. Its standard sizing works with aftermarket brackets, and the included stainless steel brackets are designed for a range of applications. For the high/low function on a 30-inch bar, the manufacturer specifies the 640119 harness, which is sold separately. Owners on user forums say a bumper install can take two people and may require trimming the plastic grille, while a flush mount means removing the grille's clip-retained tabs first. Confirm the fit for your vehicle before you buy.
No. The manufacturer states the harness is not included. For the 30-inch bar, the manufacturer specifies the 640119 harness for the high/low function, and it notes the 640115 harness is only for 10 to 20 inch bars.
Yes. The manufacturer lists high and low output for the 30-inch bar, with the high setting drawing 281W and the low setting drawing 225W. The manufacturer notes that 50-inch bars are pre-dimmed and lack this function.
According to the manufacturer, the uService program lets owners change damaged lenses or swap beam patterns without voiding the warranty.
Plan on a moderate install, and do not rush the wiring. The manufacturer describes the mounting brackets as easy to use across applications, but the harness is the main job: the bar needs its own 640119 harness, and the green control wire adds a dimming option if you wire a second switch. Owners on user forums say bumper or grille installs can require removing the bumper, trimming plastic grille material so the bar fits, and reinstalling the bumper with the grille clips. Dry-fit the bar and brackets before you finalize the wiring, and disconnect the battery before you connect power. Mount the bar, route the leads to the switch, then test both high and low before you reinstall any trim.
