The Baja Designs OnX6+ 30 inch Driving/Combo bar in amber is a straight LED light bar built around the brand's trademarked high-speed spot reflectors and a billet-machined bezel. For 453013, the manufacturer lists output of 31,910 (High); 25,450 (Low) lumens, so it throws far more usable light down a trail than a stock bumper lamp. Owners on user forums say it is very bright, and the amber lens helps when dust or fog reflects white light back at the driver.
The bar is a universal-fit unit, and the manufacturer describes its mounting brackets that can be used in any application. The wiring harness is sold separately: the manufacturer states that 640119 OnX6+ wiring harness is applicable for 30-50in. Because the harness is also what provides the hi/low switching on 30 inch bars, a buyer should order it with the light. Owners on user forums report that the brackets it came with do not work with my roof rack on some racks, so check clearance before you buy. Searches for OnX6+ 453013 install, 640119 harness, amber driving combo light bar, and dust-penetrating LED light bar are typical for this product.
No. The manufacturer lists the 640119 OnX6+ harness for 30-50 inch bars, so that harness must be purchased separately for this 30 inch bar.
The manufacturer says that the uService feature lets you customize your beam pattern or change damaged lenses without voiding the warranty on the OnX6+. Owners on user forums report that the lenses can be swapped with a small Allen wrench.
Fitment varies by rack. Owners on user forums have reported that the stock brackets did not clear some roof racks on a 40 inch OnX6 bar, and some used alternate L-brackets or rack-specific mounts instead. Measure your rack before ordering.
The manufacturer describes installation as easy, and owners on user forums say the wiring is manageable for a DIYer who uses the correct gauge wire. Plan on a harness, a fused power feed, and an Allen wrench if you want to swap lenses. Mount the bar low on the vehicle if you expect dust, because owners on user forums recommend keeping amber light below your glare points. One owner's bumper-mount install on a RAM TRX used the bar's brackets, slid the bar in from the top of the bumper, and secure the brackets and light bar assembly using the (2) 14mm screws. Check the manufacturer's installation hub for the current sheet before you start.
