The Baja Designs OnX6 30-inch Dual Control LED light bar (MPN 463014) is a straight, 30-inch bar built on the brand's OnX6 platform, with an aircraft-grade aluminum housing and a Mil-Spec hard anodized black finish. Its main advantage over a single-color bar is that the amber and white LEDs sit in two sections you can switch independently. You can run amber for dust and fog, white for distance, or both together, without buying two bars.
The manufacturer rates the Cree LEDs at up to 50,000 hours of life and a 5000K color temperature, which it says reduces driver fatigue. The OnX6 family uses Baja's High Speed Spot reflector, and its uService design lets you swap the front lens and optics instead of replacing the whole bar. That serviceable optic design, along with the billet machined bezel, is a practical reason to pay more than for a sealed bar you cannot re-pattern later. For an off-road or overland rig that needs a long-throw, amber/white, 30-inch LED bar, this is a purpose-built option.
The bar is listed as universal fit and includes stainless steel mounting brackets. The manufacturer says the OnX6 uses industry standard sizing and works with most aftermarket mounting systems, so check your bumper or roof rack mount before ordering. Plan for a dual-control wiring setup that uses two harnesses and two switches, since harnesses are not included. Confirm the exact harness part numbers against the manufacturer's installation sheet before you buy.
No. Harnesses are not included with this bar. Dual control generally requires two harnesses and two switches, one for each section. Confirm the harness part numbers against the manufacturer's installation sheet before ordering.
According to the manufacturer's OnX6 wiring guidance, the green control wire enables a dimming mode. Grounding it with a separate switch dims the light to 75 percent power. If you want the bar always dimmed without a second switch, the manufacturer includes a plug-and-play low adapter. A standard on/off setup needs only one switch.
The bar is listed as universal fit and ships with mounting brackets. The manufacturer states the OnX6 uses industry standard sizing and is compatible with most aftermarket mounting systems. Fit depends on your mounting location, so measure your bumper, grille, or roof rack space first.
Expect a wiring-focused install. The manufacturer's OnX6 wiring guidance uses a 3-pin WeatherPak connector with a black ground, a white power/on-off lead, and a green control lead for dimming. Route the harnesses and switches before you mount the bar, and keep the control lead separate from the main power run so the dimming function is wired correctly. Use the stainless hardware and the included brackets to mount the bar, and follow the manufacturer's installation sheet for pin-by-pin details. If you want the bar always dimmed, use the plug-and-play low adapter instead of wiring a second switch.
