This Baja Designs fog-pocket package pairs a Squadron 2.0 Sport spot pod with S2 Sport driving/combo and wide-cornering lights, all built to mount in the steel bumper of the 2021-2026 Ford Bronco. Each Squadron 2.0 Sport pod is rated at 3,200 lumens at 30W, and the electronics run on a 12-32V supply. For a buyer chasing a sharper trail setup, the upgrade over stock is clear: a wider lineup of beam patterns and a far brighter, more controllable light set than the bumper's factory fog location offers. The 2.0 generation also adds a integrated 9-color selectable backlight, so the look can be matched to the build without extra hardware.
The 2.0 redesign is aimed at durability and easier maintenance. The housings use a 4-pin Deutsch-style connector for a more robust harness connection, and clip-in reflectors that stay secure during lens swaps sit behind a new gasket for better sealing. Lens options include Wide Cornering, Combo, Spot, Work/Scene, and 90-degree patterns, so trail owners can tune beam shape after installation. The "UP" suffix refers to the upfitter-style wiring, which the manufacturer's install sheet describes as a main harness (upfitter or toggle switch), making this variant a practical choice for a Bronco owner wanting a clean switch setup.
The manufacturer lists this steel-bumper fog kit for the Ford Bronco 2021-2026 and the Raptor for 2022-2024. Install is a bolt-in job with a fair number of small steps: the manufacturer's sheet calls for a 10mm and ½” wrench, 9/16” and 10mm sockets, T40 Torx bit, and 4mm Allen wrench, and the battery's negative terminal should be disconnected first. Owners on user forums suggest hand-threading the bumper bolts, avoiding power tools, and leaving fasteners loose until the aim is set, since it'll make adjusting the lights after install tricky if they are fully tightened early. Searchers looking for a 2021-2026 Bronco steel bumper fog light kit with upfitter harness, Squadron 2.0 Sport spot clear, or Bronco Raptor LED pod install will find the details above useful.
The manufacturer's steel-bumper fog kit listing names the Ford Bronco Raptor for 2022-2024, alongside the 2021-2026 Bronco. Buyers with a newer Raptor should confirm the application with the manufacturer before ordering.
The manufacturer's listing for this kit specifies the OEM steel bumper. Owners should confirm compatibility with the manufacturer before purchasing if their Bronco has the plastic bumper.
Per the manufacturer's install sheet, the job calls for a 10mm and ½” wrench, 9/16” and 10mm sockets, a T40 Torx bit, a 4mm Allen wrench, and electrical tape. A drill is only listed for non-upfitter models.
The manufacturer's instructions start by disconnecting the negative battery terminal, then assemble each light to its bracket with the 4mm Allen wrench before mounting. The Squadron mounts in the largest opening of the fog pocket while the S2 lights use the double opening, and each light is secured with three T40 bolts along the top of its opening. Owners on user forums recommend hand-threading the bumper bolts, avoiding power tools, and removing the end caps to make aiming easier. Some owners also report bumper hardware seizing or breaking, and one suggests using anti-seize on the bolts and lock nuts. Several owners say the manufacturer replaced affected hardware free of charge.
