Baja Designs' S2 Sport Reverse Kit for the 2024–2026 Toyota Tacoma pairs two S2 Sport LED lights with vehicle-specific brackets that mount beneath the rear bumper. The manufacturer rates each light at 1,581 raw lumens and uses a Wide Cornering beam with a clear lens, which spreads light side to side across the bed, hitch, and tailgate area. That makes it a clear step up from factory backup lamps when you're hitching a trailer, loading a dirt bike, or working a dark job site. The manufacturer also notes the kit can double as a dust light. For buyers comparing it to cheaper bar-style reverse lights, the appeal is Baja's sealed S2 housing and its known Wide Cornering optic. The 448248 kit includes the plug-and-play trailer hitch harness, so the lights can be wired to your Tacoma's trailer circuit without a custom splice. Owners on user forums say the bumper-mounted pods hang low enough to catch on obstacles and can wash out the backup camera image, so weigh that against a hitch or bed-rail mount before you buy. Search terms this kit targets include 2024 Tacoma reverse light kit, S2 Sport LED backup lights, Tacoma trailer hitch reverse lights, and Baja 448248 install.
Installation is a bolt-on job at the rear bumper, but owners on user forums report it takes longer than a typical fog-light swap, so set aside an afternoon. Baja's published reverse-kit instructions for its earlier Tacoma/4Runner S2 kit call for 4mm and 6mm Allen wrenches, a 10mm or 12mm socket, a 13mm Allen, and a 3/4-inch drill or stepped bit, and that sheet should be checked against the 448248 installation sheet before you start. Confirm the 448248 kit is the right harness for your trim, since the upfitter harness cannot be used with it. Hybrid owners should verify the rear circuit connector before buying.
The manufacturer lists this kit for 2024–2026 Toyota Tacoma models. Owners on user forums have reported fitment problems on some hybrid models, specifically that the rear circuit wire did not match the hybrid harness, so confirm with the manufacturer before ordering for a hybrid.
No. The manufacturer states that the 448248 kit is not compatible with the Tacoma Upfitter Harness (600101). The upfitter harness is intended for the 448247 toggle-switch version of the S2 reverse kit.
Owners on user forums have reported that the two S2 pods can flood the rear camera image in low light. Aiming and placement may reduce this, but it is worth testing before committing to this mounting location.
Plan on a moderate DIY project. Remove the factory bolt on the underside of the bumper where the bracket attaches, or use the included alternate hardware if your vehicle lacks a tow-package bolt. Attach each light to its bracket, plug the splitter harness into the passenger-side light, and route the harness across the inside of the bumper to the driver side. Use the hitch harness adapter to connect to the trailer circuit. Owners on user forums report that the instructions require more steps than a typical fog-light install, so follow the manufacturer's installation sheet for the 448248 kit closely and tap into the wiring only as directed.
