The KC HiLiTES 6308 is a wiring harness for two auxiliary lights that use KC's sealed 2-pin Deutsch connectors, and it includes an illuminated switch. The manufacturer rates it for two lights up to 55 watts each, capped at 110 watts combined. Because it is a non-relay kit, it suits a KC driving or fog light setup that stays within that load, and the manufacturer says a relay is not needed.
Choose this kit over a generic loom and loose switch when you want the connectors to be weatherproof from the factory rather than hand-made splices exposed to mud and spray. The manufacturer's install sheet walks through mounting the lights loosely first, routing the harness from the battery, plugging the Deutsch leads into the lamps, and then running the switch leads to the dash. Searches for "KC 6308 harness install," "two KC lights 110W harness," and "non-relay KC wiring kit" should lead you to this exact part.
No. The manufacturer states that no relay is required for this harness, which is rated for two lights up to 55 watts each and 110 watts total.
Per the manufacturer's installation guide, the black wire connects to the ground blade, the red wire to the load (center) blade, and the yellow supply wire to the last blade on the switch.
The manufacturer describes the kit by light type and wattage rather than by vehicle. Compatibility depends on whether your auxiliary lights use the 2-pin Deutsch connector.
The manufacturer's guide for this harness lists one switch, one harness, and six wire ties as included parts. Mount the lights and loosely tighten them before you run the wiring, then route the harness from the battery or power source toward the lights and connect the DT plugs. Feed the three switch leads to the chosen panel location and wire them according to the color chart above before pressing the switch into its mount. Aim the lights before tightening them fully. The guide does not list a required tool set, so confirm the wiring steps against the manufacturer's installation PDF before you start.
