The Baja Designs 64-6307 (MPN 646307) is a pair of single-lead, 3-pin rocker switch harnesses for the REFLEX™ Light Actuator system. The manufacturer says the actuator lets you adjust a light's pitch on the fly, and the harness lets you run that movement from a switch on the dash rather than by hand. The pair harness is built for two-light setups such as single and pair light bars and A-pillar kits, and actuators are sold separately from the harness. Compared with re-aiming lights by hand or running a fixed-aim light, this gives you coverage control for climbs, descents, and high-speed trail sections without stopping.
Fitment is universal, but the actuators mount to Baja Designs universal brackets on LP Series, XL Series, S8, and OnX6+ light bars, and the manufacturer notes they are not compatible with XL Linkable light bars. If you need to run three or more actuators from one switch, the manufacturer points buyers to the 64-6306 single-lead version paired with actuator linking harnesses instead. Linking harnesses carry power only between actuators, so each light still needs its own power harness. For DIY, the manufacturer publishes an installation sheet for this part, and the actuators mount to existing brackets with included hardware. Search terms this part fits include REFLEX light actuator harness pair, UTV light bar pitch control rocker switch, and OnX6+ light bar actuator harness.
No. The manufacturer states that the harness is sold separately so it can fit existing lighting setups, so you will need REFLEX actuators or an actuator kit for the lights you plan to control.
The manufacturer directs buyers who need to control three or more actuators at once to the 64-6306 single-lead harness, which can be paired with actuator linking harnesses. The pair version is designed for two-actuator setups.
No. The manufacturer notes that REFLEX actuators are not compatible with XL Linkable light bars.
The manufacturer publishes a dedicated installation sheet for the 64-6307 harness, so check it before you start routing wire. The actuators bolt onto existing Baja Designs universal light brackets using hardware included in the actuator kit, which makes retrofitting an existing light bar or pod practical. Keep in mind that the harness only controls direction and the lights still need a separate power source, so plan your wire routing from the switch location to the actuators and to the power feed. Tie off wiring away from hot, sharp, or moving engine parts.
