This Mishimoto silicone oil cooler hose (part MMHOSE-392-21OC) replaces the factory oil cooler hose on the 2021+ Jeep Wrangler JL Rubicon 392, the V8 trim built around the 392 HEMI. The manufacturer says the stock rubber hose cracks and collapses at its bend under the repeated heat cycling the V8 produces, especially in trail and low-speed use. Mishimoto's answer is a single continuous silicone piece with embedded fiber reinforcement that holds its shape and seal under pressure. Compared with a cheaper rubber replacement, that construction addresses the exact failure point at the bend, and the Mishimoto Lifetime Warranty backs the purchase. Searchers looking for a JL 392 oil cooler hose upgrade, a Rubicon 392 silicone oil cooler hose, or a 392 factory hose replacement will find this part fits that need.
The kit includes the hose and two worm-gear clamps, so you do not need to source clamps separately. The manufacturer's fitment data lists the Rubicon 392, Rubicon 392 Final Edition, and Unlimited Rubicon 392 configurations, so confirm your exact model year and trim before ordering. Owners on user forums note that this hose and its clamp are part of the same leak-prone joint on the 392, so replacing the hose while the coolant system is already open is a sensible step. Plan on draining or recovering coolant before disconnecting, replacing the clamp, and refilling and bleeding the system afterward. Because a clamp left unseated can let coolant slip off the cooler fitting, double-check that every connection is secure before you start the engine.
The manufacturer's fitment data lists the 2021+ Rubicon 392 along with Unlimited Rubicon 392, Rubicon 392 Final Edition, and Moab 392 configurations. Because fitment details can vary between sources, confirm your exact year and trim with the manufacturer before ordering.
The manufacturer lists one oil cooler hose and two worm-gear clamps, one for each end of the hose.
The manufacturer states that the factory rubber hose cracks and collapses at the bend under repeated heat cycling, and that a single continuous silicone hose is designed to hold its shape through that bend.
The manufacturer's install instructions for this specific hose were not located in research, so follow the vehicle's service procedure and confirm details with the manufacturer. Because this hose sits in the coolant circuit at the oil cooler, plan on draining or recovering coolant before disconnecting it and refilling and bleeding the system afterward. Owners on user forums report that a dealer replaced the hose, clamp, and coolant together on a 392 with this exact leak, which suggests treating the clamp as a replacement item rather than reusing it. Forum posts also describe a coolant line that slipped off the cooler after a clamp was left off, so confirm every clamp is reinstalled and seated before you start the engine. Owners also recommend working with the engine cold and checking for leaks after the first drive.