This is a replacement fitting set for the heater supply and return hose connections on 2011-and-newer Dodge Durango models. It swaps the factory plastic quick-disconnect ends for CNC-machined 6061 aluminum fittings, and the manufacturer describes the stock plastic as a common failure point that cracks under heat and pressure. Owners on user forums report the plastic ends breaking off or leaking at the firewall, which is the weak spot this kit targets. Because you replace only the fittings and keep your existing hoses, you avoid buying a complete heater hose assembly, and the manufacturer states the install does not require passing through the firewall.
Fitment is listed by the manufacturer as a direct-fit replacement for the 2011+ Dodge Durango and Jeep Grand Cherokee. Published fitment tables differ on model-year and trim coverage, so confirm your exact year and trim with the manufacturer before ordering. For DIY work, the manufacturer says the job needs only basic hand tools. Owners on user forums, however, say access to the connection on these trucks can require removing the wipers and cowl panel, so plan for that teardown. Searchers looking for a Durango heater hose fitting upgrade, aluminum heater hose quick-disconnect replacement, or a permanent fix for a Durango heater core hose leak will find this kit addresses those needs.
The manufacturer lists it as a direct-fit replacement for the 2011+ Dodge Durango and Jeep Grand Cherokee. The year-by-year Grand Cherokee coverage was not confirmed in the manufacturer material reviewed, so verify your exact year and trim with the manufacturer before ordering.
No. The manufacturer's included-parts list covers two fittings, four O-rings, and two worm gear clamps only. You reuse your existing heater hoses and connect them to the new fittings.
The manufacturer rates the fittings for a maximum fluid pressure of 50 PSI and a maximum fluid temperature of 400°F.
The manufacturer describes installation as simple and performed without going through the firewall, using basic tools. Owners on user forums note that reaching the connection on these trucks can mean removing the wipers and cowl panel, while another owner reported that only the relevant clamps and part need to come off rather than the whole assembly. Drain coolant below the heater core connections before disconnecting anything, and make sure the O-rings are seated before you tighten the worm gear clamps. After reassembly, refill the cooling system and bleed air from the heater circuit.