Mishimoto's MMHOSE-TINY-01BK is a black silicone replacement kit for the supercharged first-generation Mini Cooper S. The kit contains four hoses, and the manufacturer describes each as high-grade silicone reinforced with heat-resistant embedded fibers, rated to 330°F. Compared with aging factory rubber, this construction is meant to add pressure tolerance while keeping the original OEM-style routing, so a buyer gets a cooling-system refresh without re-engineering the layout. Because the hoses sit close to the supercharger and intercooler, they are a practical upgrade during a thermostat, water pump, or radiator service. The lifetime warranty from the manufacturer also helps justify the higher price over basic rubber replacements.
The manufacturer lists this kit for 2002-2008 Mini Cooper S (Supercharged) hatchbacks, which covers the R53 platform. Owners on user forums note that draining an R53 is harder than most cars because there is no radiator drain plug, so most of the old coolant leaves through the lower hose and some stays in the block. Plan for the bleeding step: the kit includes an M5 x 0.8 metal plug for the bleed fitting, and the manufacturer rates installation as medium difficulty. Keyword focus: R53 Cooper S supercharged silicone radiator hose kit, MMHOSE-TINY-01BK, 2002-2008 Mini Cooper S coolant hose replacement.
The manufacturer lists this kit for 2002-2008 Mini Cooper S (Supercharged) hatchbacks. The product title shows a 02-06 range, so confirm your VIN-specific application with the manufacturer before ordering.
No. The manufacturer offers a separate silicone hose kit for 2007-2012 Mini Cooper S Turbo models, so match the kit to your engine type.
Yes. The manufacturer includes one M5 x 0.8 metal plug along with the four silicone hoses.
The manufacturer rates this kit as medium difficulty. Owners on user forums say the R53 has no radiator drain plug, so you will need to disconnect the lower radiator hose to empty the system, and they report that some coolant stays trapped in the block. Forum members recommend ramps or jack stands, a catch bucket, 10mm and 8mm wrenches, pliers, and a new hose clamp. Bleeding the air out after refilling can take patience, so keep the bleed screw open until coolant flows without bubbles and watch the temperature gauge during warm-up.