The Mishimoto Embossed Aluminum Heat Shield (MMHP-EAHS-2028) is a 20 x 28 inch sheet of heavy-duty embossed aluminum for keeping engine bay heat out of the cabin and away from sensitive components. The manufacturer rates it for continuous exposure up to 1100°F and includes the brand's lifetime warranty. Compared with a thin foil wrap, a metal panel with a published heat rating and warranty gives you a clear spec to plan around. Search terms: aluminum firewall heat shield sheet, 1100F engine bay heat shield, transmission tunnel heat shield, floor pan heat shield for track car.
The manufacturer lists this sheet for use on the firewall, transmission tunnel, floor pan, or fuel tank, so it works as a flexible blank rather than a vehicle-specific kit. Because the sheet flexes and can be snipped to shape, you can template it against your own floor pan or tunnel and trim it to match. That makes it a practical option for custom firewall or tunnel heat shielding on a project car, where a pre-formed piece may not match your layout.
Installation is a straightforward DIY job. The manufacturer rates the difficulty as easy. Plan on cutting the panel with aviation snips or similar hand shears, test-fitting it before final placement, and checking clearance to wiring, lines, and moving parts. Mounting hardware is not listed in the box contents, so choose fasteners appropriate for your panel and confirm that the shield does not contact hot exhaust components.
Yes. The manufacturer states the embossed aluminum sheet flexes and can be cut to shape for a custom installation, so it can be trimmed to match a firewall, tunnel, or floor pan layout.
The manufacturer lists the firewall, transmission tunnel, floor pan, and fuel tank as recommended locations.
According to the manufacturer, the package includes one embossed aluminum heat shield and is covered by the Mishimoto Lifetime Warranty. Mounting hardware is not listed as included.
The manufacturer rates installation as easy. Start by measuring the area you need to cover, then mark the cut line on the sheet and trim it with aviation snips or similar hand shears. Test-fit the panel before drilling or fastening anything, and keep it clear of wiring, brake and fuel lines, and moving linkages. Use fasteners suited to your mounting surface, since hardware is not supplied. Confirm the finished shield does not touch hot exhaust components.