The aFe Twisted Steel 304 Stainless Steel Long Tube Header w/ Cat (MPN 48-36005-1HC) is a long tube header for the 2.0-liter H4 (FA20) in the Toyota 86, Scion FR-S, and Subaru BRZ. Its tubing is 1-5/8 inch, mandrel-bent 304 stainless steel, built for strength and long service life. Laser-cut, machined mild steel flanges are used for a durable, leak-free seal at the head. The integrated converter is a single high-flow unit that the manufacturer describes as less restrictive than the factory converter. Owners on user forums caution that a catted header adds flow and heat that can wear a converter faster, so the cat's placement and the rest of your exhaust matter when weighing this part against a catless or equal-length alternative.
Buyers searching for an FA20 long tube header with cat, a 1-5/8 304 stainless header for 86/BRZ, or a catted long tube header for the 2013-2019 BRZ will find the key facts in this listing. Installation is designed around the factory exhaust system, using the stock mounting locations with no cutting or modifications required. Owners on user forums who have swapped similar long tube headers recommend an O2 sensor socket for the two sensors and unplugging the radiator fans before starting, since those steps reduce hassle during the swap. Confirm fitment against your VIN, because year ranges differ between sources.
The manufacturer's listing names the H4-2.0L engine and covers the Toyota 86 through 2019, the Scion FR-S 2013-2016, and the Subaru BRZ through 2019. Cars with the 2.4-liter engine are not part of that listing, so confirm with the manufacturer before ordering.
Owners on user forums report that the extra flow and heat from a catted header can wear the converter faster. Some owners instead keep a high-flow converter in the front pipe and run a catless header.
Because the header uses factory-style flanges and the stock mounting points, this is a bolt-on swap rather than a fabrication job. Owners on user forums who have done similar long tube swaps suggest a thread chaser for the bungs, an O2 sensor socket for the two sensors, and unplugging the radiator fans first, then making sure all fasteners are tightened once the car is back together. The manufacturer does not publish a difficulty rating or tool list for this specific part number in the sources I reviewed, so check the install sheet before starting.