The Dinan High Flow Middle Exhaust (part D660-0094) is a 3-inch stainless midsection for the G80 M3 and G82/G83 M4. It removes the hydro-formed factory center section from the secondary catalysts back to the axle back, including both resonators, and replaces it with larger 3-inch T304 stainless steel tubing. The forward factory resonator is replaced by a mandrel-bent X-pipe, which the manufacturer says offers minimum restriction. Shoppers searching for a G8x M3 3-inch midpipe, a G82 M4 resonator delete midpipe, or a stainless X-pipe will find this is the part that changes the sound most in the middle of the car.
Compared with a stock system or a full-cost exhaust, this part is a staged upgrade. It keeps the stock muffler, adds volume, and pairs with a Dinan axle-back. Owners on user forums argue that deleting the first resonator is the most economical mod, adding sound without spending too much in the end. This midpipe handles that job while leaving the factory rear muffler in place, which keeps the budget lower than a complete aftermarket system.
Dinan's current listing covers 2021–2026 M3 and M4 models, although its 2023 launch announcement listed 2021–2023 applications, so confirm your exact car before ordering. Installation means cutting the factory exhaust, which is covered in the DIY section below. Use the manufacturer's install sheet for D660-0094 and plan for the cut location before you start.
No. The manufacturer states that the factory muffler is kept, so only the center section between the secondary catalysts and the axle back is replaced.
Yes. Owners on user forums report that the stock system is one piece up to the primary catalysts and must be cut, whether you replace the middle section alone or together with an axle-back. Forum members describe cutting at the middle dimple ahead of the muffler and rejoining the pipes with sleeve-style clamps.
The manufacturer positions this midpipe to pair with its own axle-back system. I could not confirm fitment with other axle-backs from manufacturer sources, so check with the manufacturer before ordering for a non-Dinan setup.
This is a moderate-difficulty job rather than a bolt-on, because the factory system must be cut. Owners on user forums recommend supporting the muffler with a jack so the tips do not hang down, and they note that an impact driver speeds up the hardware. You will need a cutting tool, sleeve clamps to rejoin the pipes, and a way to support the rear section during the work. Forum members say the cut should be made at the middle dimple before the muffler so the factory muffler can stay in use. The manufacturer publishes an installation instruction document for this part, so review it before cutting. If you are not comfortable making precise cuts on the exhaust, have a qualified exhaust shop handle the job.