The K&N 30-9039 is a bolt-on DRYFLOW intake for the 3.5L V6 in 2016-2023 Toyota Tacoma trucks, built to replace the whole factory air system. Cooler, denser air is routed through a custom intake tube into the throttle body, and the manufacturer describes the power gain as guaranteed. Owners on user forums are more cautious. Many describe the change as sharper throttle response and a stronger induction sound, with smaller measurable horsepower gains on a stock truck, so choose this part for the response and sound you'll feel, not as a big dyno upgrade.
Fitment is listed for the 2016-2023 Toyota Tacoma with the 3.5L V6 F/I. Its oil-free synthetic filter media means no oiling, and the manufacturer says the filter needs cleaning only every 50,000 miles under normal highway driving conditions. Expect a 3.5L Tacoma V6 cold air intake upgrade with a lifetime-warrantied, reusable filter in place of a disposable paper element. The manufacturer says the system can typically be installed in less than 60 minutes.
No. The manufacturer states the DRYFLOW filter uses oil-free synthetic media, so it does not require oil. It should be cleaned every 50,000 miles under normal highway driving, per the manufacturer.
The manufacturer states that this intake will not void the vehicle warranty.
The manufacturer's published instructions describe a typical install of 60 minutes or less using simple hand tools. The manufacturer's general guidance for its intakes lists a ratchet, extension, 10mm and 14mm sockets, an Allen key, and a flat-blade screwdriver. Start by disconnecting the negative battery cable, but first write down your radio presets and other memory settings, since disconnecting the battery erases pre-programmed electronic memories and some radios will ask for an anti-theft code. Expect to move the mass air sensor from the factory housing to the K&N adapter using the supplied gasket. Confirm each connection is sealed and clamped before starting the truck.
