Dinan's gloss 2x2 twill carbon fiber cold air intake replaces the stock airboxes and intake tubes on the S58 3.0-liter twin-turbo inline-six in the G80 M3, G82/G83 M4, and G87 M2. The manufacturer claims 12% more airflow for your S58 with no penalty in inlet temperature or pressure. Its single central plenum feeds larger airboxes, and the manufacturer lists the filter area at 11% increase in filter area (stock: 65in², Dinan: 72in² per side). Owners on user forums say the appeal is partly visual: one describes the value as a great value option for half the price compared with pricier carbon intakes. Buyers hoping for a loud, aggressive induction note should know that one owner found the intake noise is not as loud as other intakes such as BMS.
Fitment and install questions matter most here. The manufacturer states that OEM M4 CSL & M3 CS strut brace is not compatible with the Dinan intake. Dinan's instructions begin with removing the stock front and rear brace, and they call for seating the plenum fully into the intake hoses at the end. The manufacturer lists Labor Time (Hours): 1.5. Searches for G80 M3 S58 carbon intake, G82 M4 bolt-on CAI, and M3 CSL strut brace compatibility are the questions owners ask most often.
No. The manufacturer states that the OEM M4 CSL and M3 CS strut brace is not compatible with this intake.
The manufacturer's product listing says 2021-2026 BMW M2, M3, and M4 models, while its earlier release notes list 2021-2023 G80 M3 and G82/G83 M4 models plus 2023-2024 G87 M2 models. Details vary between these sources, so confirm your exact year with the manufacturer before ordering.
Owners on user forums report that the included screws are self-tapping and can strip the threads in the factory lower airbox, which makes returning to stock more difficult. Using the right screws or replacing them is worth considering before you start.
The manufacturer's instructions cover the full procedure: remove the stock front and rear brace first, use the provided carbon airbox lids, and make sure the plenum seats fully into the intake hoses. Owners on user forums describe the job as manageable for a careful DIYer, noting that it goes in easily once the rubber pipes are level and straight and the hose clamps are pre-positioned. One owner reported crooked plenum bracket screw holes that did not line up, and the manufacturer replaced the plenum. Check the fit before fully tightening, and keep the carbon parts clear of tools during the final steps.