Dinan's carbon fiber cold air intake is built for the twin-turbocharged 4.4L V8 in the LCI BMW M550i (G30) and the G14, G15 and G16 M850i. Instead of replacing the factory lower air boxes, it reworks the lids: the manufacturer says removing the unused "U" channels enlarges the housing, raising intake volume by 54% and allowing high-flow cone filters with 22% more surface area than the stock panel filters. The manufacturer cites an 18 lb-ft torque gain at 5,500 RPM, but published horsepower figures differ between sources, so confirm the current number with Dinan before buying. Compared with a generic drop-in filter, you also get a 2x2 gloss carbon weave finish and a coverage term of the remainder of the factory limited warranty (up to 4 years/50,000 miles) or 2 years/unlimited miles, whichever is greater.
Fitment is the first thing to verify. Dinan limits this kit to the LCI M550i from 2020 onward and the G1x M850i, and states that the pre-LCI M550i engine bay layout is not compatible. Model-year ranges for the M850i vary across Dinan-affiliated listings, so check your VIN against the manufacturer's vehicle selector. Owners searching for a G30 M550i LCI carbon fiber intake, an N63 M850i cold air intake, or a replacement high-flow carbon filter will find that Dinan sells a matching spare filter for this system.
No. The manufacturer states that the pre-LCI M550i engine bay layout is substantially different and is not compatible with this Dinan intake system. Only the LCI M550i (2020 and later) and the G1x M850i are supported.
Yes. The manufacturer lists a replacement filter for the high-flow carbon fiber intake for both the 2020–2023 M550i and the M850i.
Dinan publishes installation instructions for this kit, and owners on user forums describe it as a manageable weekend job with the right tools, though it is not a bolt-on swap. One owner reported about 2.5 hours total, with the hardest step being removal of the factory accordion intake hoses. Expect to use a T25 driver for the ten screws that secure the Dinan covers to the factory bases. Those screws are not captive, so a magnetic screwdriver is strongly recommended to keep them from dropping into the engine bay, where clearances are tight. The same owner noted that the driver-side strut brace was tight to reinstall, and that one of the large hose clamps supplied was defective, so check each clamp before final tightening.