The aFe Momentum GT Pro 5R (part 50-70069R) is a vehicle-specific cold air intake built around a one-piece sealed housing and a five-layer oiled cotton filter, sized for the 6.2L V8 in 2020-2022 Ford F-250 and F-350 Super Duty trucks. Ford F-250/F-350 20-22 V8-6.2L is how the manufacturer lists its application. The manufacturer says its filter-to-housing interface was built to feature the largest air filter possible, and its inverted top makes for more filter surface area, resulting in longer service intervals.
Against the factory airbox, the manufacturer rates this kit at up to 20% airflow increase and measures it at 505 CFM @ 7" H20, with claimed gains of up to +6 HP and +9 lb-ft of torque. These are the manufacturer's own figures, so treat them as maximums rather than guaranteed results. The Pro 5R media is the street-oriented choice: the largest amount of high-flowing air, usually resulting in the highest power gains out of all our filter media options. Because the element is washable, buyers avoid repeat filter purchases between cleanings.
Common searches for this kit include 50-70069R install, 2020-2022 F250 6.2 cold air intake, washable Pro 5R filter, and Super Duty 6.2L intake upgrade. Servicing the filter does not require a full teardown, since the element comes out after only the intake tube is removed. The kit also uses stainless T-bolt clamps and a bellows coupling for a secure, flexible seal.
The manufacturer's fitment table lists 2020-2022 Ford F-250 and F-350 Super Duty trucks in XL, XLT, Lariat, King Ranch, and Platinum trims. Confirm fitment with the manufacturer before ordering for any other model year.
The manufacturer describes the Pro 5R as a washable, reusable filter. The manufacturer also offers a Pro 5R and Pro 10R air filter restore kit, part 90-51101L, which includes aerosol oil and spray cleaner.
This is a bolt-on replacement that swaps the factory airbox and intake tube for the aFe housing and tube. The manufacturer designed the kit with fewer parts to simplify installation, and it includes the stainless T-bolt clamps and bellows coupling needed for the connections. Before you start, follow the manufacturer's installation instructions for step order and torque sequence. When you finish, check that every clamp is snug and the couplings are fully seated, and confirm the mass airflow sensor harness is reconnected before starting the engine.
