Built on aFe's Track Series platform, this Stage-2 kit replaces the factory airbox on the 5.7L HEMI V8 used in 2011–2023 Dodge Challenger and Charger models and the Chrysler 300C. The intake tube is woven carbon fiber with a clear-coated finish, and an 8-inch pre-oiled Pro 5R cotton filter sits at the inlet. The manufacturer's measured flow and gain figures are its own test results, so real-world results will depend on your tune and conditions.
Compared with the stock airbox, the manufacturer reports the kit outflows the factory intake by 45%, measures 600 CFM at 7 inches of water, and quotes dyno-proven gains of up to 23 hp and 24 lb-ft. Because the Pro 5R element is washable and reusable, you avoid buying replacement filters at every service interval. Carbon fiber also keeps the intake tube light, which matters if you run this car at the track. Search terms enthusiasts use include 5.7 HEMI carbon fiber cold air intake, Challenger Charger 300C Stage-2 intake, and reusable Pro 5R oiled filter.
The manufacturer describes the Pro 5R filter as washable and reusable, so it can be cleaned and returned to service rather than replaced.
The manufacturer lists applications from 2011 through 2023 for the Dodge Challenger, Dodge Charger, and Chrysler 300C with the 5.7L HEMI V8. Confirm your model year against the fitment chart before ordering.
Per the manufacturer, both the filter and the coupler are included in this kit.
The manufacturer states that the one-piece powder-coated heat shield uses the factory mounting locations, which keeps the swap focused on the intake components rather than brackets. The kit includes the filter and coupler, so check the contents against the box before you start. Disconnect the battery, and take care that the carbon tube does not rub against hoses or the engine cover when you tighten the clamps. Confirm the full procedure, torque values, and any tuning requirement with the manufacturer's installation instructions before you begin.