The aFe Momentum HD Cold Air Intake System with Pro 10R Filter is a sealed, dyno-tuned intake for the 2.8L turbo diesel Toyota Hilux. The manufacturer builds the one-piece tube from heat-resistant cross-linked polyethylene and pairs it with an 8-inch, pre-oiled, 360-degree radial flow filter made from ten graded layers of cotton gauze. The housing draws from the factory air inlet, with an optional auxiliary inlet, and a clear window lets you check the filter without teardown.
Compared with the stock airbox, the manufacturer claims up to 60% more airflow and up to 8 horsepower from its dyno testing. The tall filter and large surface area are meant to extend service intervals in dusty conditions. Owners on user forums with the GD-6 2.8 have reported dust slipping past the stock filter seal and fouling the mass airflow sensor, so a sealed housing that mounts on the factory grommet is a practical reason to upgrade. Aftermarket listings and aFe's own pages give different model-year ranges for this intake, so confirm fitment against your VIN with the manufacturer before ordering.
Yes. Per the manufacturer's install sheet, the MAF sensor is removed from the factory airbox and remounted on the Momentum HD tube using the supplied small hex screws.
The manufacturer designs the housing as sealed and the filter as large, but aFe does not state a dust-specific guarantee. Owners on user forums report that the stock filter seal lets dust through, and some greased the filter sealing surface as a fix. Keep the filter seal clean and check it regularly.
The manufacturer's install sheet is a numbered, multi-step procedure: remove the factory airbox and MAF sensor, transfer the factory grommets, filter minder, and inlet gasket to the new housing, then seat the housing in the factory grommet. The sheet calls for a T-20 Torx bit to free the MAF sensor and small hex drivers for its reinstall. At the filter step, tighten only the larger T-bolt clamp, and at the end, snap the A/C line into the tube and secure the factory hose with the supplied fixing clamp. Work carefully with the MAF connector, and check the coupling and all clamps for a tight seal before driving.