The aFe MagnumFORCE Stage-2 Pro DRY S intake (part 54-13016D) is built for the 6.6L LML Duramax in 2011-2016 Silverado and Sierra 2500HD/3500HD trucks. The manufacturer lists it for GM Diesel Trucks 11-16 V8-6.6L (td) LML. It replaces the factory airbox, tube, and filter with an open-element XLPE housing and a dyno-tuned intake tube, and it mounts on the factory points without cutting. Owners searching for an LML cold air intake dry filter upgrade will find this to be a bolt-in swap rather than a custom fabrication job.
The Pro DRY S filter is what separates this kit from the oiled aFe options. It is oil-free, uses three layers of synthetic media, and can be washed and reused, which avoids recurring filter purchases. Some people on forums have reported oil being drawn through the intake and damaging the mass air flow sensor, so a dry element is a common choice on this platform. Gain claims differ across sources, so confirm current horsepower and airflow figures with the manufacturer before buying. Also note that this part is not legal for sale or use in California or other CARB states.
The manufacturer's listing for this part does not confirm a tuning requirement either way. Confirm with aFe before you install, and check owner reports on user forums for how the truck behaves afterward.
Yes. The manufacturer describes the Pro DRY S as a washable, reusable filter with oil-free synthetic media, so you clean it instead of replacing it.
Owners on user forums have reported occasional check engine lights in cold weather on this intake. One owner said the light appeared when ambient temperatures dropped below about 45 degrees and cleared with a code reset. Results vary, so check your truck after installation.
This is a direct-fit, bolt-on job that uses the factory mounting points, and the filter and coupler are included. Owners on user forums report about an hour of work, not counting prep and cleanup. Lubricate the temperature sensor fitting before pressing it into the grommet, since it can resist and tear. Also expect the sensor's stock retaining tab to snap when you transfer the sensor. Review the manufacturer's install guide before you begin, and disconnect the battery before working around the MAF sensor.