The KW Coilover Kit V3 for the 2013–2018 Audi RS6 (C7/4G) is a height-adjustable coilover system built on KW's Variant 3 platform, which replaces the factory strut and spring setup on cars without self-leveling. Owners on user forums describe the V3 as one of the most satisfying street-track coilover setups they have run on a C7 RS6, and the kit lets you tune ride height and damping independently. Owners on user forums also report that KW's height-adjustable springs, which keep the factory dampers, felt too soft compared with the V3, so the coilover is the stronger choice if handling is the priority.
Fitment and install require attention. Owners on user forums recommend tightening the control arm bolts thoroughly, since loose C7 control arms are known for noise. Reinstall the forward lower bolt near the tie rod boot in its original orientation to avoid abrading the boot. Plan for a wheel alignment after any height change, and expect the car to look only slightly lower until it is back on its wheels. Long-tail searches this kit answers include "RS6 C7 coilover 3521000K," "2013-2018 Audi RS6 coilover without self-leveling," "KW V3 rebound compression adjustable RS6," and "RS6 4G height adjustable coilover track day."
The listing specifies the version without self-leveling, and the manufacturer's warning, as quoted by owners on user forums, is that vehicles with electronic damping control can lose shock damping and log a system error with coilover systems. Confirm your car's damper configuration with the manufacturer before ordering.
An owner on user forums who ran a KW V3 on an Audi RS3 8Y reported that adjustments require jacking the car and removing the wheels, though some front adjustments may be reachable without removing them.
This is a moderate-to-advanced job. Owners on user forums advise that the process mirrors a standard lowering spring or coilover install. Key gotchas include ensuring the rear spring perch sits in the correct location, since user forums note that KW designs some rear setups with the perch above the spring. Get the upper mount hardware torqued to spec, and schedule an alignment once ride height is set.