The H&R 29462-2 is a street performance coilover kit for the Porsche 996 Turbo, the all-wheel-drive 911 built on the 996 platform. Each corner pairs a fully threaded shock body with a matching progressive-rate spring, so ride height can be set anywhere in a range the manufacturer lists at 1.0 to 2.25 inches front and rear. Owners on user forums say it sharpens turn-in and body control over stock struts, and that it works well on a track day on smooth roads. They also report a firmer ride over broken pavement and a busier feel in city traffic, so buyers who want a comfort-first setup should weigh that tradeoff.
The manufacturer's application listing for this kit covers the 2000 to 2004 911 Turbo, so owners of 2004 to 2005 Turbo Cabrio models should confirm fitment with H&R before ordering. Expect a meaningful install: the kit ships in loose sub-assemblies, and the instructions are thin on how the factory top-mount and washer stack should be reused. Plan on a wheel alignment after installation to restore correct geometry, and budget time for setting ride height on each corner.
The manufacturer's application listing covers the 2000 to 2004 911 Turbo. Confirm Turbo Cabrio and 2005 fitment with H&R directly before ordering.
The manufacturer lists an adjustable lowering range of 1.0 to 2.25 inches at both the front and rear. Actual ride height depends on how the spring perches are set.
Owners on user forums recommend replacing the original front top mount pieces if the car has meaningful mileage, since worn parts can affect the new setup.
Owners on user forums report installing the front units without unbolting the axle nut or tie rod, and others have removed the stock strut after disconnecting only the caliper and drop links. Results vary, so check your own clearance before starting.
This is an intermediate-to-advanced job for a home mechanic with jack stands, a torque wrench, and a spring compressor for the front units. Raise the car and support it on stands with the suspension unloaded, then remove the wheels, the shock-to-carrier bolt, the brake caliper (hung aside, not left on the hose), and the drop links so the sway bar can drop. Owners on user forums stress keeping the small dished washer at the top of the shock, following the exact order of the top-mount stack, and reusing the factory parts the instructions call for. Set the lower spring perch near the bottom of its range first, then adjust height once the car is on the ground, and get an alignment afterward.