The Dinan Adjustable Coil-Over Suspension System (D190-0901) is a spring-and-collar package for the F90 BMW M5. Rather than replacing the dampers, Dinan keeps the factory electronically controlled shocks and fits its own springs with threaded collars, so front and rear ride height can be set independently. The rear springs change from the stock progressive design to a linear rate, which the manufacturer says reduces body roll. Its springs are also rated 20% stiffer in front and 15% stiffer in the rear than stock.
The case for this kit over stock or a spring-only lowering set is electronic damping control. Because the factory EDC shocks stay in place, the car keeps its adaptive damping while gaining a lower stance and tighter body control. Owners on user forums describe the ride as firm but not harsh, and say the car feels more stable in corners. Dinan recommends a 1-inch drop in front and 1-1/8 inch in the rear to keep the ride civilized. Owners can go lower, but the manufacturer notes that ride quality suffers and that tire clearance must be checked. Bump-stop packers are included for fine-tuning. Because the install is involved, plan for a full day and a wheel alignment afterward, and confirm model-year fitment before ordering.
The manufacturer states the kit is designed to work with the stock BMW EDC front and rear shocks, and that it retains the factory electronic shocks. Owners on user forums report keeping EDC control after installation.
The manufacturer recommends a 1-inch drop in front and a 1-1/8-inch drop in the rear. Lowering further is possible, but the manufacturer warns that going beyond 1-1/8 inch in the rear reduces suspension travel and causes early contact with the bump-stops.
The manufacturer's install sheet lists the 2018–2019 F90 M5, while its product page lists 2018–2023 BMW M5 models. Confirm the correct application with the manufacturer before ordering.
This is an involved install best suited to experienced DIYers or a shop. The manufacturer's install sheet warns never to work under a vehicle held up only by a jack, so use proper jack stands. Dinan's install sheet walks through fitting the threaded perch assemblies, seating the new shock cap with its O-ring, and stacking the isolator discs, helper spring, spacer, main spring, and bump-stop on each shock. Set bump-stop clearance with the included packers to match Dinan's target values, since this clearance is critical to ride and travel. Check tire clearance before settling on final height, and schedule a four-wheel alignment afterward. Dinan's product page lists 9.2 labor hours, while its launch post cites 10.5 hours including alignment, so details vary and you should confirm the timing with the manufacturer.