MagnaFlow's BRExhaust line offers the 106-0107 as a direct-fit, factory-style replacement exhaust for the 2.0L Ford Transit Connect. The kit's precision mandrel-bent pipes are said to give better exhaust flow than the crush-bent pipes used in many competing replacement systems. That matters when you're weighing it against a cheaper replacement. The durable aluminized steel construction is meant to hold up to rust over years of use, and the kit leaves all emissions equipment intact, maintaining emissions compliance.
The kit is listed for the 2010-2013 Ford Transit Connect 2.0L and interchanges with OE parts 9T1Z-5230-A, 9T1Z-5A289-A. Installation is bolt-on. Its multi-piece layout is designed to route around axles, crossbars, and brackets, so no cutting, bending, or welding is required. Searching for a 2010-2013 Transit Connect 2.0L direct-fit exhaust replacement, a mandrel-bent aluminized steel exhaust, or a BRExhaust 106-0107 OE replacement? This kit covers all three. The two-year, unlimited-mileage warranty adds to the value.
The manufacturer lists fitment for the 2010-2013 Ford Transit Connect 2.0L. For your exact trim and body style, confirm fitment with the manufacturer before ordering.
No. The manufacturer states that no cutting, bending, or welding is required for installation.
The manufacturer says the box contains the gaskets and clamps needed for installation. Its spec listing shows gaskets as not included, so details vary. Confirm with the manufacturer before installation.
The manufacturer says the kit leaves all emissions equipment intact, maintaining emissions compliance. The catalytic converter is not included in the kit.
The manufacturer provides a two-year limited warranty with unlimited mileage.
The manufacturer describes this as a bolt-on, multi-piece system that can be fitted around axles, crossbars, and brackets. It may require basic automotive knowledge, and the manufacturer recommends professional installation. Before you start, confirm whether your box includes gaskets, since the manufacturer's materials conflict on this point. Check the manufacturer's install instructions for the complete tool list. Fit the rear sections around the existing hangers and clamp points, and check for leaks at every joint after installation.
