The MagnaFlow BRExhaust 106-0069 is a direct-fit replacement exhaust kit for the 2.5L Subaru Legacy. The manufacturer describes it as a replacement for the factory system rather than a power upgrade. It uses aluminized steel and precision mandrel-bent pipes, which the manufacturer says flow better than the crush-bent pipes found in many competing replacement systems. For a Legacy owner whose factory exhaust has rusted or worn out, that construction is the main reason to pay more than a budget replacement. The kit also ships with gaskets and clamps in one box, so you do not have to hunt for hardware separately.
This is a bolt-on job that needs no bending, cutting, or welding, according to the manufacturer. The multi-piece design is meant to route around axles, crossbars, and brackets the way the original system does. The manufacturer notes that basic automotive knowledge helps and recommends professional installation when in doubt. Before ordering, confirm fitment with the manufacturer's vehicle selector, since year and trim coverage varies across listings. Searchers looking for a 2005-2009 Subaru Legacy 2.5L replacement exhaust, a mandrel bent aluminized Legacy exhaust, or a bolt-on direct-fit Legacy exhaust kit will find this part's core specs here.
The manufacturer states that no bending or welding is required for installation. It also advises confirming fitment with its vehicle selector before purchase.
The manufacturer lists gaskets, clamps, a spring bolt kit, and a 2-piece nut and bolt kit, all packaged together in one protective box.
The manufacturer says basic automotive knowledge is needed for proper installation and recommends professional installation whenever you are unsure.
The kit is a bolt-on, multi-piece system, so the work is mainly unbolting the factory pipes and hangers and fitting the new sections in place. Because the manufacturer describes the install as requiring basic automotive knowledge, a home mechanic with lift or jack-stand experience can handle it. The manufacturer's install sheet for a related BRExhaust kit advises disconnecting the battery before removing the old system and cleaning the flange with a wire brush so the gasket seals properly. Leave all clamps loose until every section is in place, then tighten once the pipes clear the frame and underbody. Note: this step-by-step guidance comes from a related kit's install sheet, so confirm it against the manual supplied with this kit.
