The Borla 140619BC is a cat-back system from the ATAK line. It steps a 3" pipe down into dual 2.25" outlets, and it ends in truck-side tips finished here in black chrome. Borla builds it from T-304 austenitic stainless, which the manufacturer ranks above 400-series alloys such as 409 for durability. For a buyer on a 3.5L EcoBoost F-150, the case for paying more over a budget exhaust rests on materials and fit, not just sound.
Borla's mandrel bends and CNC manufacturing are intended to keep exhaust flow smooth and the fit accurate, and the manufacturer presents the system as a way to free up power that stock plumbing holds back. The manufacturer says the aggressive ATAK tone is tuned to avoid drone inside the cab. Owners on user forums describe the installation as straight forward, pretty easy, which matters if you plan to do the swap in your own driveway rather than pay shop labor.
Borla lists this cat-back for the 2015–2020 Ford F-150 in both 2WD and 4WD. Before ordering, confirm your engine, cab, and bed against the manufacturer's application chart, because fitment varies by configuration. On the install itself, the manufacturer's guide says to insert the hanger into the original rubber isolator, so the factory mounts are reused. Lubricate the hangers, isolators, and fasteners before you start, and the manufacturer recommends a hoist or hydraulic lift. Expect some smoke on the first start, since the tubing carries a protective coating that disappears once the exhaust reaches normal operating temperature. Keep the provided heat shield wrapped on the brake line.
Per the manufacturer's installation guide, the new system's hangers are inserted into the original rubber isolators, so the factory mounting points are used.
The manufacturer states that the smoke comes from a protective oil-based coating used on mandrel-bent performance tubing. It is not a defect and should clear once the exhaust reaches normal operating temperature.
Owners on user forums report that you can lower the spare rather than remove it. Others suggest removing the spare and its heat shield, or raising the truck, if you are working in a driveway without ramps.
The manufacturer lists bright chrome 4" T-304 tips as one option and black chrome tips as an alternative finish on the same system.
Owners on user forums call the job straightforward, but they note that it is easier with a hoist or ramps. The manufacturer's F-150 guide lists a 3/8" ratchet with a 6" extension, 10mm and 15mm deep-well sockets, 13/16" and 15/16" sockets, and a pry bar. Let the vehicle cool for at least 1 hour if it has been in use before you work under it, and always wear eye protection when working under any vehicle. Start by lubricating the hangers, isolators, bolts, and nuts, then work through the mid pipe and muffler connections, and leave the clamps loose until the entire system is aligned.