The Borla 140287 is an S-Type cat-back exhaust with 2.5-inch tubing, engineered for the Pontiac G8 GT's 6.0L V8 and the G8 GXP's 6.2L V8. The system features a Merge X-Pipe for increased performance and improved sound. Exhaust exits through dual 3.5" round polished T-304 stainless steel tips on each side. Compared with a budget mild-steel replacement, T-304 stainless holds its finish and resists corrosion better over years of road salt exposure. The manufacturer says it delivers the classic S-Type sound with no drone inside the vehicle.
Fitment is listed for the 2008-2009 G8 GT 6.0L and GXP 6.2L, with automatic or manual transmissions in rear-wheel-drive four-door sedans. Owners on user forums report the install is manageable, but aligning the tips, both in how they sit side to side and how far they stick out past the bumper, was the fiddliest step. One owner also found the driver side compression flange that squeezes up to the cat was installed backwards, so the flared end had to be cut, flipped, and re-welded. Search terms this kit matches include G8 GT cat-back, G8 GXP S-Type exhaust, 140287 X-pipe, and 6.0L V8 exhaust upgrade.
The manufacturer lists this system for the 2008-2009 G8 GT 6.0L and the GXP 6.2L, with either transmission and rear-wheel drive. Details vary across sources on the GXP model year, so confirm your exact year with the manufacturer before ordering.
The manufacturer specifies dual 3.5-inch round polished T-304 stainless tips, one on each side.
The manufacturer states the S-Type tuning is designed to avoid drone inside the cabin. Owner experience on highway drone was not confirmed during research.
Owners on user forums describe this as a bolt-on job that runs about an hour on paper and often takes longer, mostly due to tip alignment and any fitting problems in the front flange. Plan on a lift or ramps with jack stands, penetrating lubricant on the clamps and hangers, and a helper to hold the pipes while you set the isolators. Before you start, check the driver-side flange at the catalytic converter for correct orientation. No G8-specific install sheet from the manufacturer turned up in research, so confirm the procedure and torque specs with the manufacturer.