Borla's 140084 is a 2-inch stainless cat-back system for the E46 BMW 323, 325, and 330 range. The manufacturer lists it for 2001-2006 E46 models with 2.5/3.0L six-cylinder engines, with automatic or manual transmissions, rear-wheel drive, and 2- or 4-door bodies. It uses dual 3.15-inch round polished T-304 stainless tips. Owners on user forums say the sound is deeper and throatier than stock without being overbearing, and the manufacturer says the classic S-Type tone comes without drone inside the vehicle. Compared with budget cat-backs, the stainless construction and warranty the manufacturer describes as outlasting the vehicle are the main reasons to spend more.
Check fitment before ordering. Details vary across sources, especially at the edges of the model-year range, so confirm your exact year and engine with the manufacturer. Long-tail searches this part answers include E46 330i cat-back exhaust, 325i S-Type catback, and M54 3.0 Borla sport exhaust. For installation, owners on user forums describe the system as bolt-on and say it uses the factory hanger points. The main hurdle reported is rust. One owner said rusted factory bolts made removal a pain and needed to be cut. Owners also suggest using a lift with jack stands. The manufacturer provides an installation guide, so review it before you start.
The manufacturer lists 2001-2006 E46 models. Fitment data elsewhere differs at the edges of that range, including 1999-2000 323i and 2006 330i applications, so confirm your model year with the manufacturer before ordering.
Owners on user forums describe it as a bolt-on swap that reuses the factory hanger points. Some owners reported that hangers or tip alignment needed adjustment, so check alignment before final tightening.
Owners on user forums describe it as only slightly louder than stock, with a deep tone outside the car. The manufacturer states the S-Type design is meant to avoid drone inside the cabin.
Expect a moderate, bolt-on job that takes most of a day for a home mechanic. Owners on user forums recommend working on a lift or with ramps and jack stands for clearance. Soak the factory fasteners and hanger points in penetrating lubricant before you start, because corroded hardware is the most common delay. Have a helper or a jack to hold the system while you reconnect the hangers. Use the manufacturer's installation guide to check hanger positions and tip alignment before final torque.