The Borla 14902 is an S-Type cat-back exhaust built for the B5-generation Audi S4 and its 2.7-liter turbocharged V6 with quattro all-wheel drive. The manufacturer specifies 3-inch tubing that ends in dual left rear exits with 3.14-inch polished T-304 stainless tips. The system is CNC-cut for a repeatable fit, and Borla's straight-through and multi-core muffler design, along with mandrel-bent piping, is meant to reduce restriction compared with the factory back half. For buyers searching for a 2000 2001 2002 Audi S4 B5 2.7T cat-back, this is a bolt-on upgrade that replaces the rear of the stock exhaust.
The reason to pay more than stock or a budget kit is the material and tuning. The manufacturer builds the system from T-304 austenitic stainless, which it presents as a step up from T-400 series grades such as 409 for long-term durability. The S-Type tone is tuned to stay free of cabin drone at highway speed, which matters on long drives. For a 2.7T V6 owner who wants a sharper exhaust note without the rasp of a generic kit, this is a T-304 Borla S-Type option built to specific fitment rather than a universal pipe.
The manufacturer states the S-Type system is designed to deliver its sound without drone inside the vehicle. Drone tolerance can still vary with how the system is aligned and with the rest of your exhaust, so check fit and hanger position after installation.
The manufacturer lists the sedan and Avant wagon under this part number. Published sources disagree on the model years covered for the wagon, so confirm your exact year and body style with the manufacturer before ordering.
Owners on user forums report that the rubber hangers must be released before the stock pipe can come out, and that the middle hangers are usually the hardest. Many recommend a dedicated exhaust hanger tool and penetrating lubricant on the stubborn bolts.
This is a bolt-on job for a driveway mechanic with a jack or ramps, a jack stand set, and a socket set. The manufacturer publishes installation instructions for this part, so review them before starting. Owners on user forums say the factory system is easiest to remove when the rear hangers are unbolted or released first, and that the rubber hangers near the middle of the car are the hardest to free. Some owners also advise against exhaust putty at the slip joints because it hardens and cracks when the joints are adjusted. Expect to loosen the clamps and hanger bolts more than once to set tip alignment and clearance under the valance, then tighten everything once the pipes sit level and centered.