Free Shipping on Orders Over $99  ·  No Code Needed

Mishimoto 08-16 Ford Super Duty Regular Cab Silicone Body Mounts

*Photo may not represent actual product

This Mishimoto Silicone Body Mount Kit is a six-bushing replacement set for 2008–2016 Ford Super Duty F-250 and F-350 trucks in Regular and Extended Cab form. Every bushing uses a silicone compound instead of the rubber or foam found in factory cab mounts. The set is meant to hold the cab steady on the frame and reduce the noise, vibration, and harshness that worn stock mounts pass into the cab. Searches for 2008 F-250 cab mounts, silicone cab mount kit, and cab sag fix often lead to this exact kit.

Owners on user forums describe creaking over bumps and a cab that no longer sits square over the bed as typical signs of failed mounts. Aftermarket urethane replacements are often criticized for squeaking and harshness, and the manufacturer positions its silicone as the answer to both problems, claiming it resists cracking and hardening over time. The included hardware is Dacromet-coated for corrosion resistance, and the kit is backed by Mishimoto's Lifetime Warranty. That combination matters when the alternative is paying shop labor to repeat a job that can take hours. Fitment varies by model year and engine, so confirm your truck's specifications with the manufacturer before ordering.

  • Brand: Mishimoto
  • Part Number (MPN): MMBM-F2D-08RC
  • Bushing Material: Silicone
  • Bushings Per Kit: 6 (Regular and Extended Cab)
  • Fitment: 2008–2016 Ford Super Duty F-250 / F-350, Regular and Extended Cab
  • Crew Cab: Requires the separate 8-bushing kit
  • Hardware Finish: Dacromet-coated
  • Drilling or Modification: None required
  • Warranty: Mishimoto Lifetime Warranty

FAQ:

Does this kit fit a Crew Cab Super Duty?

No. The manufacturer's kit lineup uses a separate eight-bushing kit for Crew Cab trucks, while this six-bushing set is intended for Regular and Extended Cab trucks.

Do I need to lift the cab to install these mounts?

Owners on user forums report that on many installs the cab has to be raised slightly and supported so the upper mount can slide out. They also note that the forward mounts can be harder to reach through the engine bay on some model years.

Can I remove the bolts with an impact wrench?

Owners on user forums advise against impact tools, because the captive nuts can spin inside their cage. They describe heating the bolts to soften threadlocker, then loosening them slowly with a breaker bar.

Installing it yourself

The job is moderate in difficulty, and the main challenge is access rather than complexity. Owners on user forums report anywhere from a couple of hours to most of a day for a full set, depending on rust and experience. Plan on a breaker bar, sockets, jack stands, a way to support the cab, and a torch or induction heater for stubborn threadlocker. Avoid impact guns on both removal and installation. Owners also suggest raising the cab only slightly, just enough to free the upper mounts, and inspecting every fastener for rust before you start. Once the mounts are fastened, check that the body lines fall where they should.

  • MPN: MMBM-F2D-08RC
  • Manufactured by: Mishimoto
  • Units per SKU: 1
  • On Order: 3
Exclusive member pricing Free membership — sign in to see your price
Join Free →

$349.95

MSRP / List price
Member Price
Your price after signing in
$349.95
Add to Cart:
MPN
MMBM-F2D-08RC
Manufacturer
Mishimoto
Availability
Out of Stock
Ships Within
1–2 Business Days
Member Pricing
Easy Returns
Expert Support
Secure Checkout