The EBC USR1197 is a rear slotted brake rotor for the 2006 to 2009 Ford Fusion 2.3L, built on Ford's CD3 platform, which also underlies the Mercury Milan, Lincoln Zephyr and Mazda 6. The USR, or Ultimax Slotted Rotor range, is our premium, silent street range designed for fast street use. This rotor uses a narrower multi-slot layout cut at a progressive angle, which the manufacturer says creates a quiet running sport rotor that still has benefits of removing gas, dirt, water and debris and maintaining parallel pad wear. Against a stock smooth rear rotor, that slot pattern is the main reason to upgrade: it targets even pad contact and a quieter ride, not just stopping power on paper. Look for it when you want a quiet-running rear upgrade for a daily-driven 2.3 Fusion that still sees spirited use.
Construction is the second reason to pay more than for a budget replacement. It is made using the highest quality R90-approved G3000 grey iron rotor blanks. The manufacturer also states that all EBC rotors, including USR Slotted Rotors, are British-made and precision machined in the UK or the USA. Confirm the application against your VIN before ordering, since this listing covers the 2.3L engine only. Searchers looking for a 2.3 Fusion rear slotted rotor, a quiet Ultimax sport rotor, or an EBC USR1197 replacement will find this part's profile matches those needs.
Owners on user forums report that the rear calipers on the 2006 to 2009 Fusion screw in rather than clamp, so the piston has to be wound back. Forum members generally recommend a dedicated rear caliper retraction tool over improvised pliers, which they describe as harder to use.
Owners on user forums say rear rotors can be stubborn to remove, especially on cars that have seen road salt. Cleaning the hub flange and applying a thin layer of anti-seize before installing the new rotor is the prevention method they commonly describe.
This is a manageable driveway job with basic hand tools, but it is not a fast one. Plan on a rear caliper retraction tool, a socket set, penetrating oil, a rubber mallet, WD-40 or similar for the stud holes and center bore, and anti-seize. Work one side at a time so the untouched side serves as a reference for hardware placement. Owners on user forums say the new rotors can take real effort to seat and that spending roughly 30 minutes per side is typical. The most common gotcha is a rotor that has bonded to a rusty hub, which often needs a firm mallet, penetrating oil, and careful hub cleaning before the rotor will come off.