The PowerStop Evolution AR8773XPR is a front rotor pair with cross-drilled holes and rounded slots, offered for the 2005-2010 Chrysler 300. PowerStop drilled and slotted rotors provide a bolt-on upgrade for improved brake cooling and performance. The drilled holes pull heat off the friction face during repeated hard stops, and the slots wipe away gas, dust, and moisture so the pad keeps a clean contact patch. Each Evolution drilled and slotted rotor is plated with silver zinc-dichromate for protection against rust and corrosion, and each one is checked and balanced for smooth braking. For a 300 owner who wants better fade resistance on spirited drives or track days without a full big-brake conversion, this is a practical step up from stock rotors that keeps the factory caliper and hub setup.
Break-in matters more with these than with plain rotors. The manufacturer calls the break-in procedure critical to brake performance, because it lays down an even layer of pad friction material on the rotor face. Its sequence includes a run of five moderate stops between 35 and 5 mph made back to back, without letting the brakes cool. On the install side, owners on user forums report that rotors on these cars can rust fast to the hub face, and penetrating oil applied around the lug studs followed by a few firm hammer strikes on the rotor face often breaks them loose. The listed application is the 2005-2010 Chrysler 300, but engine and drivetrain variants exist, so confirm your submodel against the manufacturer's fitment guide before ordering.
Yes. The manufacturer describes break-in as critical for optimal performance, and its procedure is designed to deposit an even friction layer from the pads onto the rotors before normal use.
The manufacturer states that the Evolution drilled and slotted rotors are designed to perform as a bundle with PowerStop brake pads, so pairing them with matching pads is the manufacturer's recommended setup.
This is a standard front brake rotor swap that a home mechanic can handle with basic hand tools, a torque wrench, and a jack with stands. Before removing the rotor, check behind it for retaining clips or screws, since owner discussions note these can prevent the rotor from coming off. If the old rotor is stuck to the hub, use penetrating oil around the lug studs and tap the face or back of the rotor with a hammer, then clean the hub mating surface. Apply a thin coat of brake grease to the backs of the pad shims and the caliper bracket contact points, make sure the parking brake is released, and bed in the new rotors using the manufacturer's break-in procedure.