The EBC GD931 is a rear GD Sport rotor for the 2000–2006 Audi TT Quattro 1.8T rated at 225bhp. Now in their third generation, the rotors feature silver corrosion protection. EBC GD Series sport rotors are 100% machined in the U.K. from R90-approved blanks, with the majority cast in the EU. For an 8N-chassis TT Quattro, that gives you a sportier look and a more heat-tolerant rear disc than stock, for street driving and occasional spirited or track-day use.
The main reason to pay for the GD design over stock or a plain cheaper disc is cooling and debris management. The GD wide aperture slots help maintain even pad wear, run cooler, and expel dirt, mud, water, and dust from the braking area. The dimpled face, which EBC calls its dimple drilled design, is meant to let heat and gases escape from the pad interface. Owners on user forums are split on how much real stopping gain slotting and drilling deliver. Some argue pad choice matters more for fade resistance, so pair these rotors with a quality high-friction pad rather than expecting the disc alone to change braking performance.
Owners on user forums report that 180bhp Quattros run solid rear rotors while 225bhp cars use vented units, and this GD931 is listed for the 225bhp car. Check your existing rear disc type before ordering.
Owners on user forums say an upgraded pad produces a very noticeable improvement, and that high-performance pads matter most for avoiding fade in aggressive driving. Confirm pad compatibility with the manufacturer before buying.
Owners on user forums describe this as a fairly approachable rear job for a home mechanic. After removing the wheel and the pads, the caliper comes off with two 13mm bolts at the pins and two 17mm bolts that hold the carrier to the hub. Suspend the caliper from a wire rather than letting it hang by the brake hose. The rotor is retained by a small screw that often seizes from rust, so an impact driver with a Phillips bit helps, and forum members sometimes tap the disc free with a mini-sledge. Wire-brush the hub clean before fitting the new disc, and consider a brake fluid change if the fluid is more than two years old.