The EBC RK7199 is a plain, non-slotted replacement rear rotor for the 2004-2008 Acura TL 3.2 automatic. It is made to the same spec as original parts using G3000 grey iron. It is a solid rotor, sold as a pair, with a Geomet-type coating. Its dimensions are a 282mm diameter and 9mm new thickness, with a 59mm height, 64.2mm center bore, and 5-lug pattern.
Compared with worn stock discs or cheaper rotors that only look similar, this set is sized and shaped to OE factory dimensions and machined to tight tolerances. Leaving out the slotting is meant to mirror the factory-installed rotors. The coating is intended to provide corrosion resistance, which matters on rear hubs that rarely see heat cycles. Buyers searching for an 04-08 TL rear rotor replacement, a non-slotted 282mm solid rear disc, or an EBC RK7199 upgrade over OEM will find this a straightforward, street-focused choice.
Owners on user forums report that the rear e-brake shoes can hold the rotor in place, and that rust can bind the disc to the hub. Removing the rubber plug on the rotor face and backing off the e-brake adjuster lets the shoes retract so the rotor can clear them.
Owners on user forums say the rotor has threaded holes that can take bolts, which can be turned a little at a time to press a stuck disc off the hub. Tapping the hat area with a rubber mallet is another method reported.
This is a moderate DIY job for someone comfortable with a jack and stands. Owners on user forums describe the rotor as held by Phillips-head screws, so keep a driver that will not cam out, plus a rubber mallet, penetrating oil, a flat-blade screwdriver for the e-brake adjuster, and a torque wrench. Remove the caliper, then the rotor, and clean the hub face of rust before fitting the new disc. Check the lug nut torque and bedding procedure against the Acura service manual, and confirm your caliper configuration before ordering.