The Wilwood BP-30 pad set (part 150-30-7812K) is a four-pad set built on the manufacturer's pad plate 7812 shape at .490 inch thickness. The manufacturer classifies the BP-30 compound as a high-temperature racing pad: high friction with a medium initial bite that rises as rotor temperature climbs, low wear during sustained high-heat braking, and very high fade resistance. For a track or autocross car that repeatedly loads its brakes, that heat stability is the real reason to pay for this compound over a general-purpose performance pad. Pick it for hot-lap stops, not everyday commuting.
Fitment is tied to the caliper, so verify before you order. The manufacturer's pad-plate listings for 7812 include its Dynapro and Billet Dynalite caliper families and UTV4 and UTV6 calipers. Owners on user forums describe mixed cold-weather behavior, with some reporting weak initial bite until the pads warm up, so plan on a few gentle stops before you push. Bedding matters. The manufacturer's procedure covers light and medium decelerations followed by eight to ten hard stops from 55 to 65 mph down to 25 mph, performed only on a race track or other safe location, with a uniform burnish left on the rotor face afterward.
The manufacturer lists pad plate 7812 for its own Wilwood calipers, including the Dynapro and Billet Dynalite families and UTV4 and UTV6 models. Confirm your caliper against the manufacturer's pad fitment information before ordering.
Yes. The manufacturer's bedding procedure should be carried out only on a race track or other safe location, and it ends with a post-bedding inspection of the rotor surface.
Owners on user forums report mixed results. Several say the pads have little bite when cold and recommend warming them up first, and some caution against using them on the street because of rotor wear when cold.
Install the pads with the friction material facing the rotor and secure them with the caliper's retaining hardware, following the manufacturer's assembly instructions for your caliper. Apply thread locker to the caliper mounting bolts, reinstall the wheel and torque the lug nuts to specification, then bleed the brake system and check for leaks. Use a catch bottle with a hose during bleeding, and confirm the wheel spins freely before driving. Plan the bedding session on track, and if smearing or splotching appears on the rotor faces, the manufacturer notes that the brakes were likely brought up to temperature too quickly. Sanding or resurfacing may be needed if the smear does not blend away.