The Power Stop Z23-1846 is a rear-axle pad set from the Z23 Evolution Sport line, built on a carbon-fiber-infused ceramic compound. The manufacturer describes a low-dust ceramic formula, infused with carbon-fiber, for increased braking power without sacrificing everyday drivability, and each kit includes premium stainless-steel hardware and a pin bushing kit. An owner on a user forum who switched a CX-5 to these Z23 pads said they were very pleased and found them much better than the factory pads. Compared with a budget organic or semi-metallic replacement, that combination of lower dust, quieter operation, and consistent fade resistance is what justifies the price. Search terms this kit targets include Z23-1846 rear pads, 2016-2019 CX-5 carbon ceramic brake pads, and low dust rear brake upgrade.
Fitment should be matched to your exact model year, trim, and drivetrain before ordering. Rear pad work on 2016 and newer CX-5 models is more involved than on older generations because the rear calipers use an electronic parking brake. Mazda's service documentation calls for maintenance mode before and after rear pad replacement on the CX-5. The electric actuator motors must be retracted before the rear caliper pads can be changed. Owners on user forums also recommend a proper rear caliper piston tool rather than improvised methods. For the pads themselves, proper pad bedding can help prevent rotor warping, so follow the break-in sequence closely after installation.
Yes. The manufacturer's service documentation requires maintenance mode before and after rear pad replacement on the CX-5 with electronic parking brake. Retracting the actuator motors first is necessary before the rear pistons can be pushed back.
The manufacturer recommends five moderate stops from 35 mph to 5 mph without letting the brakes cool, then a cooling stage of driving at moderate speed for about five minutes without coming to a complete stop. Avoid holding the pedal down on hot rotors, since the manufacturer notes this can imprint the pad on the rotor.
Yes. The manufacturer states the kit includes premium stainless-steel hardware and a pin bushing kit for a smoother installation.
This is a moderate DIY job for someone comfortable with rear disc brakes, but the electronic parking brake adds steps that a standard pad swap does not have. Plan on jack stands, wheel chocks, a caliper piston tool or heavy-duty C-clamp, a wire brush for cleaning the caliper rails, and a torque wrench. Put the parking brake into maintenance mode first, as the manufacturer's documentation requires, and only then compress the rear pistons. Owners on user forums warn that the caliper may not clear new pads until the piston is fully retracted, and that pad ears must slide freely in the bracket grooves. Clean and lubricate the slide surfaces with the included ceramic lubricant, then finish the break-in procedure described above.