The EBC Greenstuff DP61542 is a rear pad for the 4.4-liter V8 Land Rover LR3, and it sits in EBC's Greenstuff range. The manufacturer describes its Greenstuff 6000 Elite line as an upgrade for SUVs and light trucks, with an upgrade pad for Light Truck and SUV that improves brake effect 10+ %. Owners on user forums have run Greenstuff pads on the rear of an LR3 and report low dust and noise. Against stock pads, the manufacturer says the compound is cleaner pads than stock, and it resists heavy brake use without brake "Fall-Off". Owner opinions on value are mixed, so weigh the price against the dust and noise gains you want.
For the rear axle of a 4.4 V8 LR3 (Discovery 3), this is a practical street-and-towing upgrade for buyers searching for a low-dust LR3 rear brake pad, a quieter LR3 4.4 rear brake upgrade, or an EBC Greenstuff Discovery 3 rear pad. Fitment years differ between sources, so confirm your VIN with EBC before ordering. The pad is designed to bed in quickly, since the Greenstuff line uses a red brake-in surface coating for safe braking right after installation. Rear pad changes on this platform are manageable at home, but the electric parking brake must be handled correctly, so plan the job carefully.
Fitment year ranges vary across sources, and the manufacturer's confirmed application list was not located during research. Owners on user forums have fitted Greenstuff pads to the rear of an LR3, but confirm your exact model year and VIN with EBC before ordering.
Owners on user forums advise replacing the wear sensor every time the pads are changed, since the sensor is usually bent or damaged during removal.
Owners on user forums report that Land Rover does not recommend turning rotors at a pad change, and that rotors can warp when machined.
Owners on user forums describe the rear pad change as a manageable driveway job, roughly twenty minutes per wheel once the vehicle is jacked and the wheel is off. Plan on a floor jack, stands, a lug wrench, a C-clamp or old pad to press the piston back, and pliers for the wear sensor. Remove the caliper lower bolt, slide out the old pads from their clips, and seat the new pads with the anti-rattle clips in place. Forum members also note that the wear sensor clip can be easily lost, so keep track of it. The electric parking brake must be put into service mode before the rear piston is pressed back, and a community guide, Bodsy's Brake Bible, covers the full procedure.