The Power Stop K8528-26 is the rear half of the Z26 Street Warrior upgrade for the C8 Corvette, sold as a matched set of pads and rotors. The pads use a carbon-fiber reinforced ceramic compound built for muscle and modified cars, and the rotors come drilled and slotted with a silver zinc rotor plating that resists rust. The manufacturer says the compound enhances heat dissipation versus a typical ceramic brake pad, which matters once you push the car on back roads or at a track day. Stainless shims and a pin bushing kit are also included.
Choose this kit over stock hardware if wheel dust is your main complaint. One owner on a user forum reports brake dust has almost completely gone away and says they could not detect a difference in braking performance, while other forum members describe a softer initial bite than OEM pads, so details vary by owner. Fitment is the detail to verify: owners on user forums list different rear pad numbers for the base and Z51 setups, with base rear pads Z26-8008 versus Z51 rear pads Z26-8010. For a home mechanic, the rear job is a practical weekend project with the right sockets, a rubber mallet, and a proper bedding routine. Search terms this kit matches include C8 Corvette rear brake pads and rotors, non-Z51 rear carbon ceramic kit, and low dust C8 Corvette brake upgrade.
No. Owners on user forums report that the Z51 rear pad uses a different number (Z26-8010) than the base rear pad (Z26-8008). Confirm your car's package before ordering.
The manufacturer states its brake kits are designed to fit the existing brake system without modification.
The manufacturer recommends five moderate stops from 35 mph to 5 mph in rapid succession without letting the brakes cool, followed by about five minutes of moderate driving without coming to a complete stop. Never cool the brakes with water.
Owners on user forums describe the rear install as straightforward, and one owner said a single packet of the included grease was barely enough for the rear job. Plan on a 10mm socket for the negative battery cable, a 15mm for the parking brake caliper bolts, and a 22mm for the lug nuts, plus an 18mm ratcheting wrench and a rubber mallet for the rear caliper bolts. A small flat-head screwdriver helps release the plastic rear brake line clip. Lubricate the caliper hardware generously. The manufacturer notes that many rear pistons screw in and out, so a C-clamp may not retract them, and that the brakes should be bled per the factory service manual.