The PowerStop Z23 Evolution Sport K8172 is a front brake upgrade kit for the 2019 GM 1500 (Silverado 1500 and Sierra 1500). It pairs Z23 carbon-fiber ceramic brake pads with drilled and slotted, zinc-plated rotors. The manufacturer describes the Z23 compound as a step up from traditional ceramic pads for braking power, and as a low-dust formula. Because the kit ships as one set, you avoid sourcing pads, rotors, shims, and hardware separately. Those parts include dual-layer rubberized shims, premium stainless-steel hardware, and high-temperature brake lubricant. It is built for a daily-driven truck that sees occasional towing or light off-road use, and it installs as a bolt-on upgrade over stock calipers.
Fitment details vary across sources. Some list the 2019 Silverado 1500 only, while others cover a wider year range, so confirm your trim, axle, and 6-lug configuration with the manufacturer before ordering. For DIY installers, the manufacturer's guide calls for a jack, jack stands, a C-clamp, brake pad grease, and DOT 3 or 4 brake fluid. It also says not to use a torque gun and to tighten lug nuts in an alternating pattern. Bed the new pads before normal use. The manufacturer's procedure is 5 moderate-to-aggressive stops from 40 to 10 mph without letting the brakes cool, followed by a cooling stage. Keywords: 2019 Silverado 1500 front brake kit, Z23 ceramic pads, drilled slotted rotors, GM 1500 brake upgrade, low dust truck brakes.
No. The manufacturer offers a separate Z23 Evolution Sport kit that includes powder-coated calipers. The K8172 kit covers pads, rotors, shims, stainless hardware, and lubricant, and it is designed to work with your stock calipers.
Owners on user forums report that rubbing and squealing often fade once the pads are properly bedded. The manufacturer says proper break-in is critical, because skipping it can cause brake pedal pulsation and thermal shock that leads to rotor stress cracks.
Per the manufacturer's general installation guide, the job is a standard front pad and rotor swap, so basic hand-tool experience is enough. Plan for a jack, jack stands on level ground, a C-clamp to retract the caliper piston, brake pad grease, a torque wrench, and fresh DOT 3 or 4 fluid if you open the system. Gotchas: the guide advises against using a torque gun, and it calls for tightening lug nuts to the vehicle's specified torque in an alternating pattern. Do not hold the pedal down while the rotors are hot, because the pad can imprint the rotor and cause judder. Finish with the manufacturer's bedding procedure, and never cool the brakes with water.