The Power Stop K7411-26 is the rear-axle pads-and-rotors configuration of the Z26 Street Warrior line, pairing carbon-fiber ceramic pads with drilled and slotted rotors and stainless-steel hardware. The manufacturer says this pairing is meant to shorten stops under the most demanding conditions, which is the real case for paying more than stock: a setup aimed at repeated hard stops from a high-output street vehicle, not a budget pad swap. Because the manufacturer sells a separate version that adds powder-coated calipers, this is the choice when your existing calipers are in good condition.
Confirm fitment against your VIN and trim before ordering, since application listings differ. Owners on user forums have debated whether drilled and slotted rotors with ceramic pads suit regular towing, so weigh your use case first. Plan a proper bed-in: the manufacturer calls break-in critical, describing a sequence of firm stops from about 40 mph down to 10 mph without coming to a full stop, followed by a second round from lower speeds, and warns that a resin odor is normal during the process.
No. The manufacturer's pads, rotors and stainless-steel hardware kit is listed separately from its Z26 Street Warrior version that includes powder-coated calipers, so calipers are not part of this configuration.
Yes. The manufacturer states that break-in is critical to brake performance because it lays down an even layer of pad friction material on the rotors. It describes repeated firm stops without letting the brakes cool, avoiding full stops, and expecting a resin smell as the brakes heat up.
This is a bolt-on rear brake job rated by the manufacturer as light to moderate mechanical skill, with roughly 2–3 hours of work based on its install sheet for a related Z26 vehicle. Expect to need a floor jack, four jack stands, a ratchet, a torque wrench, and a 13mm socket for the rear caliper slide pin bolts. Chock the front wheels and loosen the lug nuts before lifting. On the Enclave, the electronic parking brake must be put into service mode before the rear calipers come off, and owners on user forums report this step trips up first-time installers, so look up the menu sequence for your model year. Fit the new rotors, reinstall the spring clips and pads, and torque the caliper bolts to spec. If a bleeder valve is opened or a brake line is loosened at any point, bleed the system before driving. Check rotor runout before final assembly when you can.