The PowerStop K7352 is a front-axle upgrade for the Acura MDX, built on the brand's Z23 Evolution Sport platform. The kit pairs Z23 carbon-fiber ceramic pads with drilled, slotted, and zinc-plated rotors, plus dual-layer rubberized shims, stainless-steel hardware, and hi-temp brake lubricant. Against stock pads, the manufacturer says the compound increases braking power while keeping everyday drivability intact, and the kit's design aims to limit heat buildup under severe conditions. Designed to Perform as a Kit
Owners on user forums point to the MDX's factory front rotors as a recurring weak spot, which makes a sturdier aftermarket rotor a sensible upgrade. One owner reported a first set of front PowerStop brakes lasting 60k without any warpage, and others say the combination of ceramic brake pads and drilled/slotted rotors work well. Opinions are not unanimous, since some enthusiasts argue a decent coated rotor is enough for street use, so weigh drilled rotors against your own driving habits.
Expect a standard bolt-on front job for 2017–2019 Acura MDX owners searching for MDX front brake pads and drilled slotted rotors. Year coverage is not consistent across the sources reviewed, so verify your VIN against the manufacturer's fitment guide before ordering. Bedding matters: the manufacturer's break-in routine calls for five moderate stops from 35 mph to 5 mph in rapid succession, followed by a cooling drive, and proper pad bedding can prevent rotor warping. Owners on user forums have reported glazed pads after light bedding, so commit to the full procedure on your MDX front brakes.
No. The manufacturer sells a separate version of this Z23 Evolution Sport kit with powder coated calipers. The K7352 covers the pads, rotors, and hardware only.
Yes. The manufacturer states that break-in is critical for optimal performance, and the procedure establishes an even friction layer on the rotors. Complete the bedding steps before normal driving.
Owners on user forums have reported glazing that they linked to light bedding pressure, with one noting they were too light on the pedal when bedding. Follow the manufacturer's break-in steps closely to avoid this.
The manufacturer's install guidance calls for PowerStop pads and rotors, brake fluid as specified in your owner's manual, and brake component lube. The brake fluid reservoir should be about half full. Never allow the caliper to hang from the brake hose, as this can cause damage to the brake hose. Clean any rust off the hub mating surface with a wire brush, and install the new hardware, since worn or damaged hardware can lead to noise or poor brake pad performance. Torque the caliper bracket bolts to the vehicle manufacturer's specifications, and keep brake lube off the friction side of the pads. Take care not to twist the brake hose when reinstalling the caliper. Finish with the bedding routine described above.