The Power Stop Z23 Evolution Sport rear brake kit (K6977) replaces the stock rear rotors and pads on the Subaru WRX with a matched set. It includes drilled and slotted zinc-plated rotors, carbon-fiber ceramic pads, rubberized shims, stainless steel hardware, and high-temperature brake lubricant. Because the pad compound and rotor surface are sold together, the setup is meant to work as one system rather than as mismatched parts from separate shops. Compared with a pad-only swap, the drilled and slotted rotors help shed heat and gas during repeated stops, and the zinc plating protects the rotors from surface rust. The kit is designed to bolt onto stock rear calipers, so buyers avoid the expense of a full rear caliper upgrade.
Fitment is the first thing to verify. Listings place this kit on 2015 through 2021 WRX models, and some sources say it is not intended for cars equipped with EyeSight. Confirm your model year, trim, and parking brake setup with the manufacturer before ordering. For DIY installers, this is a bolt-on job for anyone comfortable with a floor jack, jack stands, and a torque wrench. Long-tail searches for this kit include 2015 WRX rear Z23 brake upgrade, carbon ceramic pad drilled slotted rotor kit, and WRX rear brake pad and rotor kit with stock calipers.
Fitment information varies between sources, and some indicate the kit is not intended for EyeSight-equipped cars. The manufacturer should be contacted with your VIN or exact year and trim before ordering.
The kit is designed for use with the stock rear calipers, so a caliper replacement is not required for the standard K6977 kit.
Per the manufacturer's brake kit installation guide, start by chocking the wheels still on the ground, setting the parking brake if the rear wheels stay down, and breaking the lug nuts loose before lifting. Support the car on jack stands at the manufacturer's specified jacking points, then work one side at a time so the other side remains as a reference. Remove the two caliper guide pin bolts, lift the caliper off the bracket, and support it with a caliper hanger or sturdy wire, since the manufacturer cautions against letting it hang from the brake hose. Tools typically needed are a jack, jack stands, a socket set, a torque wrench, and a caliper hanger. The kit includes stainless hardware, a pin bushing kit, and lubricant. Rear parking brake setup can add steps, so check the procedure for your specific car before starting.