The K6534-26 is the front-axle pad-and-rotor package from PowerStop's Z26 Street Warrior line, aimed at high-horsepower muscle and modified Corvettes. The kit pairs Carbon-Fiber Ceramic Brake Pads with drilled and slotted rotors, and premium stainless-steel hardware and pin bushing kit comes along for the install. Owners on user forums say they stop as well as the Brembo pads and produce far less dust, which is the main reason C7 Corvette drivers pick this Z26 front set for a street-driven car.
Owners who skip pricier ceramic options such as Carbotech often cite cost as the deciding factor (trying to avoid the high cost of the Carbotech equivalent). The manufacturer says its design keeps brake temperatures down during extreme operating conditions. Results are not uniform, though. One owner had no cold-bite problem but saw reports from people that did, and some posted photos show a brownish rotor tint while other owners report none (some posted pics where rotors do have a brownish tint). Details vary, so confirm with the manufacturer before ordering if rotor appearance matters to you.
Fitment and install deserve as much attention as the stopping performance. On user forums, one owner of a 2017 Grand Sport with two-piece iron rotors found that a Z26 front pad was too tall by about 3/8", so verify your rotor configuration before buying. Do not stack old Brembo shims under these pads, because the Z26 pads already include a stainless shim (Do not stack the Brembo shims onto the PowerStop pads). Per the manufacturer, bed in the pads with 5 moderate stops from 35 mph to 5 mph in rapid succession without letting the brakes cool, since proper bedding can prevent rotor warping.
The manufacturer describes this kit as pads, rotors, and stainless-steel hardware. It offers a separate Z26 Street Warrior kit with powder-coated calipers for buyers who want calipers included.
User forums report mixed results. Some owners have seen brownish rotor discoloration, while others report no browning after many miles. Confirm current guidance with the manufacturer.
Owners on user forums advise against it. The Z26 pads already include a stainless steel shim, so stacking the factory Brembo shims is not needed.
Owners on user forums describe pad and rotor swaps as fairly easy with the right tools, so a driveway install is realistic for a mechanically inclined owner. Plan on a proper bedding procedure after installation: the manufacturer notes the brakes will get very hot, and resin odor during bedding is normal. Keep the rotor surfaces clean and lightly scuffed before fitting, and if you keep your original rotors, clean out the cooling grooves first. Two-piece rotor setups take longer because the inner hat is retained and the outer ring is replaced with several fasteners, which owners describe as a bit of a pain.