Power Stop's Z23 Evolution Sport front kit (MPN K3029) is a bolt-on pad and rotor upgrade for the front axle of the 2004-2008 Acura TL. The pads use a carbon-fiber reinforced ceramic compound that the manufacturer says delivers fade-free braking and cleaner wheels, and the drilled and slotted rotors are designed to sweep away gas and debris from the pad contact surface. Choose this kit over a pad-only swap when you want the pads and rotors matched as one system, with stainless hardware and pin bushings included. It is a daily-driver upgrade, not a track-spec brake, so it suits spirited street driving and commuting. Plan on a proper bedding procedure. The manufacturer calls it critical to performance, and skipping it can lead to pedal pulsation.
Searches for 2004-2008 Acura TL front brake upgrade, Z23 carbon ceramic pads, drilled and slotted rotors, and low-dust ceramic brake kit all point to this configuration. Owners on user forums describe the job as manageable at home with basic hand tools. They warn that rotor retaining screws often seize, and that a rotor fused to the hub by rust may need a few firm taps or two M8 x 1.25 bolts threaded into the rotor to push it free. Caliper bolt torque varies across forum posts, so confirm the figure in a service manual before reassembly.
The manufacturer specifies five moderate-to-aggressive stops from 40 mph down to 10 mph without coming to a complete stop, followed by five moderate stops from 35 mph to 5 mph. Afterward, the manufacturer recommends about five minutes of moderate driving without heavy braking to let the pad resin cool and cure.
Owners on user forums report that rust bonds the rotor to the hub, and that the retaining screws can seize. Common fixes include drilling or impact-driving the screws out and threading M8 x 1.25 bolts into the rotor's holes to push it off.
Owners on user forums cite differing values. Base-model figures around 37 lb-ft appear often, while some Brembo-equipped owners cite much higher numbers. Confirm the correct figure in the service manual for your specific caliper before you tighten anything.
This is a front brake pad and rotor replacement that a home mechanic can handle with a few hours and basic tools. Owners on user forums list a torque wrench, 14mm, 17mm, and 19mm sockets or wrenches, an impact driver for the rotor screws, a C-clamp or caliper piston tool, and brake grease. Keep the caliper hanging by its hose rather than letting it dangle, lubricate the pad backing plate edges where they contact the caliper, and bleed the brakes after the pads are seated, pumping the pedal until firm. Use new hardware from the kit, because the manufacturer notes that improper hardware can cause noise and poor pad performance.