This front-axle kit from PowerStop's Z23 Evolution Sport line is built around a carbon-fiber ceramic pad. The manufacturer describes the pad as a low-dust formula that adds braking power, which is the main reason to choose it over a plain OE-style replacement. The kit is sold for the 2002-2006 Acura RSX front axle. Rotors are drilled and slotted, and a silver zinc plating is applied for rust and corrosion resistance behind open wheels. Precision drill holes allow for maximum rotor cooling, and the rounded slots wipe away gas and debris, which keeps the pad contact patch clean during repeated stops.
For an RSX that sees spirited street driving or occasional track-day sessions, the value is in stopping consistency and fewer dust-caked wheels, not in raw cosmetic change. The kit includes premium stainless-steel hardware and pin bushing kit for easy, problem-free installation, so a home mechanic gets the slide pins and clips needed for a clean swap. Search terms this kit targets include 2002-2006 RSX front brake pads and rotors, carbon ceramic RSX brake upgrade, drilled slotted RSX front rotors, and low-dust Z23 RSX brake kit. Because details for this part number vary across sources, confirm the exact pad and rotor configuration against the manufacturer's documentation before ordering.
The manufacturer offers its Z23 upgrade with powder-coated calipers as a separate kit. The standard Z23 upgrade kit is built around pads, rotors, and stainless-steel hardware, so check the part description and the manufacturer's fitment tool before ordering if you need calipers.
Owners on user forums report that bleeding the system is not required when only the pads and rotors are replaced, as long as the caliper is not disconnected from the hose. Follow the manufacturer's install guidance and keep the reservoir from overfilling.
The manufacturer's procedure starts with 5 moderate to aggressive stops from 40 mph down to 10 mph in rapid succession without letting the brakes cool and do not come to a complete stop. Next, complete 5 moderate stops from 35 mph to 5 mph in rapid succession without letting the brakes cool. Finish with a cooling drive, and never cool your brakes with water, as this can damage them.
Owners on user forums describe a pad-only swap on this chassis as roughly an hour of work per axle, which fits a weekend driveway job with jack stands, a torque wrench, and 12mm, 17mm, and 19mm sockets. Rotors take more effort: the caliper bracket has to come off before the rotor will slide free, and one forum owner noted that the spindle nut requires a special socket and breaker bar, so acquire those tools before you start. Use a piston tool or C-clamp to retract the piston, which has extended as the old pads wore. Keep grease off the friction faces and rotor surface, and install the included hardware and shims in the order the manufacturer's install guide shows. Once the wheels are torqued, complete the bedding sequence above before any hard braking.