The CRK9013 is a rear brake kit from PowerStop's Z17 Evolution line, pairing Z17 ceramic pads with Geomet-coated rotors for the Buick Encore GX. Brake rotors are fully coated, including inside the vanes, to extend rotor life, which matters on open-spoke wheels where the vanes are visible and prone to rust. Owners looking for a stock-style rear upgrade get a matched set rather than mixing parts from different brands. The pads use dual layer high temp rubberized shims that the manufacturer says insulate noise. Its low-dust compound was validated through on-vehicle 3rd party tests, so buyers can expect cleaner wheels than with basic organic pads. Year coverage is reported inconsistently across sources, so confirm your exact model year, trim, and rear brake setup before ordering.
This is a bolt-on, do-it-yourself upgrade for the rear axle. No modifications are needed to the vehicle, and the kit ships with stainless hardware and high-temperature lubricant. Plan on bedding the new pads and rotors properly. The manufacturer's break-in routine calls for 30 decelerations from 30 mph to 5 mph with 30 seconds in between each deceleration for cooling. A resin odor during early heat cycles is normal. Searchers looking for a Z17 Evolution Geomet rear brake kit, low-dust ceramic rear pads for Encore GX, or a coated rotor and pad upgrade for daily driving will find this kit matches those needs.
Fitment details vary across sources, with different year ranges appearing for the Encore GX. Confirm your exact year, trim, and rear brake configuration with the manufacturer's fitment data before ordering.
Yes. The manufacturer recommends 30 decelerations from 30 mph to 5 mph, with 30 seconds of cooling between each, and says a resin smell during heat-up is expected.
Replacing both pads & rotors together leads to more long-lasting performance and allows the pads to create an initial layer of friction on the rotors, according to the manufacturer.
The manufacturer's Z17 Evolution kits include rotors, Z17 ceramic brake pads, and stainless-steel hardware, and the kit also supplies high-temperature brake lubricant for the installation.
The kit is designed as a straight rear swap, so you will need a jack, jack stands, a torque wrench, and standard hand tools. Clean the hub surface before fitting the new rotor, and use the supplied high-temperature lubricant only where the instructions call for it. Once the wheels are back on, run the manufacturer's bedding procedure before any hard stops, and keep the pads and rotors on the same schedule. Confirm the rear caliper's parking-brake service procedure for your specific model before disassembly.