Power Stop's S2712 is a remanufactured pair of front brake calipers for the 2001-2007 Toyota Sequoia, sold without mounting brackets so you can reuse your factory hardware. All new premium boots and seals are used, along with high-temperature silicone lubricant on the caliper pins, according to the manufacturer. Each unit is also 100% pressure tested and inspected to verify piston operation. That testing, plus new internals and a corrosion-resistant red powder coat, is what separates this kit from a used caliper of unknown condition, and it is the reason to pay for a reconditioned set over a salvage part.
Fitment depends on the caliper casting, not just the model year. Fits models with the 13WL calipers only. Owners documenting first-generation upgrades describe swapping the older 13WE casting for the 13WL unit, so check the casting before ordering. For DIY work, the front calipers are fixed, and owners on user forums recommend removing the pins and anti-rattle spring, then compressing both pistons together so the opposite side does not push out. Pulling some fluid from the reservoir first prevents overflow, and coating the pad backs with a molykote compound helps prevent squeal. After reconnecting the line, you need to bleed/flush the entire brake system, not just the two calipers you changed. Searches for 2001-2007 Sequoia front red calipers, 13WL caliper upgrade, and first-gen Sequoia big brake caliper swap lead to this exact application.
Look for the casting marking on the back of the existing caliper. Owners consistently point to the 13WL casting as the deciding factor, so match that marking rather than relying on the model year alone.
No. The manufacturer names this kit as calipers without brackets, so your existing brackets are reused during installation.
Yes. Owners on user forums advise bleeding the whole system after a caliper swap, starting with the corner farthest from the master cylinder and working toward the closest one.
This is a moderate DIY job for someone comfortable with basic brake work. Because the front calipers are fixed units, the pads come out after the pins and anti-rattle spring are removed. Owners on user forums recommend compressing both pistons at the same time with two pry tools, removing some fluid from the master cylinder beforehand, and reinstalling the stainless abutment clips that come with the kit. Plan on a full brake bleed when you finish, and use a vacuum or one-person bleeder setup if you work alone.