The Battery Tender PowerPlus 24V 20A on-board charger (MPN 022-2012-DL-WH) is a hardwired 24-volt charger and maintainer for battery systems that 12V units can't properly serve. The manufacturer rates it at 24V and 20 amps and backs it with a 2-year limited warranty. It is designed for both standard lead-acid and lithium packs, and the manufacturer describes it as IP68 waterproof with UL marine ignition protection. Its 20-amp output recovers a 24V bank far faster than a trickle maintainer, and it switches to maintenance charging once the battery is full.
The strongest case for this unit is application fit. The manufacturer lists heavy-duty diesel trucks, Class 8 semis, forklifts, dump trucks, some marine vessels, and certain RVs and commercial vans as typical 24V platforms, which is where a cheaper 12V-only charger falls short. Owners on user forums who mounted it under the hood in the battery box secured it with heavy-duty velcro and reported the battery terminals stayed accessible. Forum members also raise under-hood heat as a concern and suggest mounting farther from the engine bay. Searchers looking for a 24V truck battery charger, a 20 amp lithium-compatible maintainer, or a permanent on-board 24V charger install will find this model fits those needs.
The manufacturer states the charger supports both lead-acid and lithium batteries at its full 20-amp output.
The manufacturer includes a 4.9 ft DC output cable and 12 ft ring terminal accessory cables with a 40A inline fuse, which together give over 12 feet of total reach.
The manufacturer's manual states the charger produces no output until it senses a correctly polarized battery, so the rings will not spark if they contact each other while disconnected.
The manufacturer's manual lists a 30A, 250V fuse for the 24V 20-amp model (022-2012).
Permanent mounting is a moderate DIY job. The manufacturer's install guidance calls for 8mm and 10mm wrenches or a socket set for the battery terminal bolts, plus dielectric grease on the connections. Confirm battery polarity first, since the positive post is usually the larger of the two. Connect the red positive lead to the positive post, then run the negative lead to a heavy-gauge metal part of the frame or engine block away from the battery. The manual specifically warns against clamping rings to the carburetor, fuel lines, or sheet-metal body panels. When disconnecting, switch the charger off, unplug the AC cord, remove the chassis ring, and then remove the battery ring. If the battery sits in a hard-to-reach spot, the manufacturer's guide describes quick-disconnect pigtails and extended ring terminal cables as alternatives to running long leads.